LPC2220FBD144 NXP Semiconductors, LPC2220FBD144 Datasheet - Page 31

• Manufacturer Part Number: LPC2220FBD144
• Description: IC, 16/32BIT ARM7 MCU, 64K RAM, SMD
• Manufacturer: NXP Semiconductors

Specifications of LPC2220FBD144

• No. Of I/o's: 76
• Ram Memory Size: 64KB
• Cpu Speed: 75MHz
• No. Of Timers: 2
• No. Of Pwm Channels: 6
• Digital Ic Case Style: LQFP
• Supply Voltage: RoHS Compliant
• Core Size: 32bit
• Oscillator Type: External Only
• Controller Family/series: LPC22xx
• Peripherals: ADC, RTC
• Rohs Compliant: Yes

NXP Semiconductors
LPC2210_2220_6
Product data sheet
6.21.1 EmbeddedICE
6.21.2 Embedded trace
6.21.3 RealMonitor
Standard ARM EmbeddedICE logic provides on-chip debug support. The debugging of
the target system requires a host computer running the debugger software and an
EmbeddedICE protocol converter. EmbeddedICE protocol converter converts the remote
debug protocol commands to the JTAG data needed to access the ARM core.
The ARM core has a Debug Communication Channel (DCC) function built-in. The debug
communication channel allows a program running on the target to communicate with the
host debugger or another separate host without stopping the program flow or even
entering the debug state. The debug communication channel is accessed as a
co-processor 14 by the program running on the ARM7TDMI-S core. The debug
communication channel allows the JTAG port to be used for sending and receiving data
without affecting the normal program flow. The debug communication channel data and
control registers are mapped in to addresses in the EmbeddedICE logic.
The JTAG clock (TCK) must be slower than
interface to operate.
Since the LPC2210/2220 have significant amounts of on-chip memory, it is not possible to
determine how the processor core is operating simply by observing the external pins. The
Embedded Trace Macrocell (ETM) provides real-time trace capability for deeply
embedded processor cores. It outputs information about processor execution to the trace
port.
The ETM is connected directly to the ARM core and not to the main AMBA system bus. It
compresses the trace information and exports it through a narrow trace port. An external
trace port analyzer must capture the trace information under software debugger control.
Instruction trace (or PC trace) shows the flow of execution of the processor and provides a
list of all the instructions that were executed. Instruction trace is significantly compressed
by only broadcasting branch addresses as well as a set of status signals that indicate the
pipeline status on a cycle by cycle basis. Trace information generation can be controlled
by selecting the trigger resource. Trigger resources include address comparators,
counters and sequencers. Since trace information is compressed the software debugger
requires a static image of the code being executed. Self-modifying code cannot be traced
because of this restriction.
RealMonitor is a configurable software module, developed by ARM Inc., which enables
real-time debug. It is a lightweight debug monitor that runs in the background while users
debug their foreground application. It communicates with the host using the debug
communication channel, which is present in the EmbeddedICE logic. The LPC2210/2220
contain a specific configuration of RealMonitor software programmed into the on-chip
flash memory.
Rev. 06 — 11 December 2008
1
6
of the CPU clock (CCLK) for the JTAG
16/32-bit ARM microcontrollers
LPC2210/2220
© NXP B.V. 2008. All rights reserved.
31 of 50