CV500II101 Omron, CV500II101 Datasheet - Page 16

• Manufacturer Part Number: CV500II101
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500II101

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Connecting Programming Consoles
1-3-2 CVM1D PCs
4
Programming
Console
Note A Unit to which a Programming Console is connected must be set to a baud rate
Note A CVM1D Backplane cannot be used for a SYSMAC BUS/2 Slave Rack.
II201
II201
IC
Programming Consoles or other Programming Devices cannot be connected
directly to the CPU Unit of a CVM1D Duplex System. Connect to the Duplex Unit
instead of the CPU Unit.
The CVM1-PRS21-EV1 Programming Console can be used for the CVM1,
CVM1D, and CV-series PC, but not for C-series PCs. The Programming Con-
sole can be connected to the following Units.
Programming Devices cannot be connected to both the Duplex Unit and an I/O
Interface Unit at the same time on the same PC. Connect to only one of these at
any one time.
It is possible to connect a maximum of four Programming Devices to the same
PC, i.e., one to either the Duplex Unit or I/O Interface Unit and up to three to SYS-
MAC BUS/2 Remote I/O Slave Units. If one is not connected to the Duplex Unit
or I/O Interface Unit, up to four can be connected to SYSMAC BUS/2 Remote I/O
Slave Units. A maximum of two Programming Consoles, however, can be con-
nected to Slaves under the same Remote I/O Master Unit.
of 50 kbps. The baud rate for the I/O Interface Unit is set on the DIP switch on the
Duplex Unit.
Expansion I/O Rack
Expansion I/O Rack
CVM1D-DPL01 Duplex Unit
CV500-II201 I/O Interface Unit (Expansion I/O Rack)
CV500-RT211 Optical SYSMAC BUS/2 Remote I/O Slave Unit
CV500-RT221 Wired SYSMAC BUS/2 Remote I/O Slave Unit
CVM1D CPU Rack
RM
PS PS
PS PS
PS PS
RT
RT
Programming Console
Programming Console
Programming Console
PS
PS
SYSMAC BUS/2
Slave Rack
SYSMAC BUS/2
Slave Rack
Section 1-3