T1610000 Red Lion Controls, T1610000 Datasheet - Page 18

• Manufacturer Part Number: T1610000
• Description: Process/Temperature Controller
• Manufacturer: Red Lion Controls
• Type: Temperaturer

Specifications of T1610000

• Operating Temperature Max: 50°C
• Operating Temperature Min: 0°C
• Output Voltage Max: 250VAC
• Controller Input: Thermocouple Or RTD
• Supply Voltage Max: 250VAC
• Mounting Type: Panel Mount
• Brand/series: T16 Series
• Contact Form: SPST
• Dimensions: 49.5mmW×49.5mmH×115.3mmD
• Enclosure Rating: IP65
• Input Type: RTD/Thermocouple
• Ip Rating: IP65
• Memory: EEPROM
• Output Type: Relay
• Power, Rating: 8 VA
• Primary Type: Controller
• Special Features: EEPROM
• Standards: cURus, CE
• Termination: Screw
• Voltage, Supply: 85 to 250 VAC
• Thermocouple Type: J, K, T, E, R, S, B, N, C And Linear MV
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

be set for Cooling. (For P16 Controllers, the cooling output is sometimes
referred to as secondary output.) When set to cooling, the output no longer
operates as an alarm but operates as a cooling output. The O2 terminals are the
same as A2, however a separate O2 annunciator indicates Cooling Operation.
Cooling output power ranges from -100% (full cooling) to 0% (no cooling,
unless a heat/cool overlap is used). The Power Limits in Output Module
also limit the cooling power. In applications requiring only a Cooling output,
the main 01 output should be used.
independent cycle time for cooling. A setting of zero will keep output O2 off.
to balance the effects of cooling to that of heating. This is illustrated in the
Heat/Cool Relative Gain Figures. A value of 0.0 places the cooling output into
On/Off Control.
7.5 MODULE 5 - C
To enable Cooling in Heat/Cool applications, the Alarm 2 Action must first
CYC2
This cycle time functions like the O1 Output Cycle Time but allows
GAN2
This defines the gain of the cooling relative to the heating. It is generally set
2. 0
1. 0
0. 0
0. 0
to
to
250. 0
RELATIVE GAIN
10. 0
CYCLE TIME
Heat/Cool Deadband = 0
seconds
OOLING
HEAT/COOL RELATIVE GAIN FIGURES
PARAMETER MENU
(S
Heat/Cool Deadband > 0
ECONDARY
18
(negative value) or the deadband area between the bands (positive value). If a
heat/cool overlap is specified, the percent output power is the sum of the heat
power (O1) and the cool power (O2). If Relative Gain is zero, the cooling
output operates in the On/Off Control Mode, with the On/Off Control
Hysteresis CHYS in Output Module 2-OP becoming the cooling output hysteresis.
The function of Deadband is illustrated in the Control Mode Explanations. For
most applications, set this parameter to 0.0 prior to starting Auto-Tune. After
the completion of Auto-Tune, this parameter may be changed.
db-2
This defines the overlap area in which both heating and cooling are active
0
) P
ARAMETERS
Heat/Cool Deadband < 0
-999
DEADBAND/OVERLAP
to
9999
(
)