MCR-S10-50-UI-DCI-NC Phoenix Contact, MCR-S10-50-UI-DCI-NC Datasheet - Page 11

• Manufacturer Part Number: MCR-S10-50-UI-DCI-NC
• Description: INTERFACE ANALOG
• Manufacturer: Phoenix Contact

Specifications of MCR-S10-50-UI-DCI-NC

• Input Type: 0 - 9.5A, 0 - 55A
• Output Type: Current Or Voltage
• No. Of Output Channels: 2
• Accuracy: ± 0.5%
• Supply Voltage Range: 20VDC To 30VDC
• Approval Bodies: CE, UL Recognised
• External Depth: 114.5mm
• External: RoHS Compliant
• External Length / Height: 99mm
• Rohs Compliant: Yes

5.4
Before starting up the measuring transducer, please ensure
that the module configuration data matches the measuring
requirements. The configuration data for a preconfigured
device can be found on the right hand side of the housing.
If you are using an unconfigured measuring transducer,
there is a standard configuration, which can be found in the
order keys on page 5 and page 8. If the desired
configuration does not match the label on the side of the
housing or the standard configuration, refer to the section
below.
5.5
Figure 2
100241_07_en
Configuration of the input
threshold value output
Configuration of the
Ready for operation
measuring process
Configuration of the
current range and
Fine adjustment of
Open the housing
Threshold value
Startup
Configuration Flowchart
analog output
Configuration
programming
the measuring
output
Configuration flowchart
or
Configuration via DIP switches
Yes
Programming
No
Software
package
5.5.1
The MCR-S-…-DCI generation offers the advantage of a
choice between configuration and programming.
MCR/PI-CONF-WIN software can be used to freely
program the true r.m.s. value current transducer.
Programming is described in the software manual. The
user-friendly configuration software runs under all popular
Windows operating systems.
In addition to programming, modules can be parameterized
using DIP switches and potentiometers.
The rest of this section deals with configuration:
5.5.2
Using a screwdriver, release the locked upper part of the
housing on both sides. The upper part of the housing and
the electronics can now be pulled out approximately 3 cm.
Figure 3
Configuration or Programming
Opening the Housing
The measuring transducer must not be
started up when the housing is open.
Opening the housing
PHOENIX CONTACT
M C
A r
t . - N
R -
r . :
S -
1 - 5
2 8
- U
1 4
MCR-S-…-DCI
I - S
6 5
W -
D C
0
I
11