ADNS-3060 Avago Technologies US Inc., ADNS-3060 Datasheet - Page 6

• Manufacturer Part Number: ADNS-3060
• Description: Optical Mouse Sensor,DIP
• Manufacturer: Avago Technologies US Inc.

Specifications of ADNS-3060

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q2073278B

PCB Assembly Considerations
Figure 5. Exploded view drawing
1. Insert the sensor and all other electrical components
2. Insert the LED into the assembly clip and bend the
3. Insert the LED/clip assembly into PCB.
4. Wave Solder the entire assembly in a no-wash solder
5. Place the lens onto the base plate.
Figure 6. Block diagram of ADNS-3060 optical mouse sensor
6
LED_CTRL
into PCB.
leads 90 degrees.
process utilizing solder fixture. The solder fixture is
needed to protect the sensor during the solder pro-
cess. It also sets the correct sensor-to -PCB distance as
the lead shoulders do not normally rest on the PCB
surface. The fixture should be designed to expose
the sensor leads to solder while shielding the optical
aperture from direct solder contact.
RESET
MISO
MOSI
SCLK
NCS
CTRL
PROCESSOR
IMAGE
OSCILLATOR
OSC_IN
OSC_OUT
REFB
REFC
OPTP
NPD
V
GND
DD3
6. Remove the protective kapton tape from optical
7. Insert PCB assembly over the lens onto the base plate
8. The optical position reference for the PCB is set by the
9. Install mouse top case. There MUST be a feature in the
3.3 V POWER
REFERENCE
VOLTAGE
FILTER NODE
aperture of the sensor. Care must be taken to keep
contaminants from entering the aperture. During
mouse assembly process, it is recommended that the
PCB is held vertically when kapton tapes are being
removed.
aligning post to retain PCB assembly. The sensor ap-
erture ring should self-align to the lens.
base plate and lens. Note that the PCB motion due to
button presses must be minimized to maintain optical
alignment.
top case to press down
RESONATOR
ADNS-2220 (Clip)
ADNS-3060 (Sensor)
Customer supplied PCB
Customer supplied base
plate with recommended
alignment features per
IGES drawing.
HLMP-ED80-XX000 (LED)
ADNS-2120 (Lens)