FLASH-CAN-48P-M26 Fujitsu, FLASH-CAN-48P-M26 Datasheet - Page 12

• Manufacturer Part Number: FLASH-CAN-48P-M26
• Description: BOARD, EVAL, FOR 16 BIT FLASH MCUS
• Manufacturer: Fujitsu
• Type: Evaluation Boardr

Specifications of FLASH-CAN-48P-M26

• Kit Features: 16bit MCU In FPT-48P-M26 Package, In-Circuit Serial Flash Programming, Reset-Button, Reset-LED
• Mcu Supported Families: F2MC-16FX
• Silicon Manufacturer: Fujitsu
• Kit Contents: Board
• Features: In-Circuit Serial Flash Programming, UART Interface
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

3.3 Power Supply Voltage (JP: 29, 34)
Vcc and GND (Vss) are both connected to the edge-connector (X4) in order to supply
additional circuitry. In this case take care of not to exceed the maximum ratings of the on
board voltage regulator LM317T.
JP29 Power Supply selection
JP30 Power Supply voltage selection: +5V or +3.3V
JP34 This Jumper is used to connect the Vcc supply voltage to the µC.
Default: JP29 = 1-2, JP30 = OFF, JP34 = ON,
By default, the on-board Voltage +5V regulation is used and the microcontroller is powered.
UG-900002-19
JP34 (MCUVcc)
JP30 (3V3)
JP29 (Vcc)
Jumper
Connecting an Ampere-meter instead of the jumper allows measuring of the power-
supply-current of the microcontroller (Icc).
ON (closed)
ON (closed)
OFF (open)
OFF (open)
Setting
1 - 2
2 - 3
Chapter 3 Jumpers and Switches
Description
On-board voltage regulation
not supported
voltage regulation adjusted to +3.3V
voltage regulation adjusted to +5V
Power supply Vcc is connected to µC
Disconnected from Power supply Vcc
FLASH-CAN-48P
- 12 -
© Fujitsu Microelectronics Europe GmbH