FLASH-CAN-48P-M26 Fujitsu, FLASH-CAN-48P-M26 Datasheet - Page 23

• Manufacturer Part Number: FLASH-CAN-48P-M26
• Description: BOARD, EVAL, FOR 16 BIT FLASH MCUS
• Manufacturer: Fujitsu
• Type: Evaluation Boardr

Specifications of FLASH-CAN-48P-M26

• Kit Features: 16bit MCU In FPT-48P-M26 Package, In-Circuit Serial Flash Programming, Reset-Button, Reset-LED
• Mcu Supported Families: F2MC-16FX
• Silicon Manufacturer: Fujitsu
• Kit Contents: Board
• Features: In-Circuit Serial Flash Programming, UART Interface
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

5 Connectors
5.1 Power connector (X12)
The following figure shows the power connection jack X12. This connector is used to
connect an external unregulated DC power supply voltage (9V-12V DC) to the evaluation
board.
Connector X12:
It is recommended to use 9V to keep the power dissipation to a minimum. Otherwise, an
additional heat sink for the linear voltage regulator might be necessary.
5.2 Edge connector (X1, X2)
All pins of the microcontroller are directly connected to X1 and X2, both are 2 x 12 Pin
headers, as follows:
The odd pin numbers are located on the one side and the even pin numbers are located on
the other side of the connector.
On the PCB, the corresponding pin numbers of the µC are written next to the connector pins.
5.3 UART”A”, UART”B” connector (X3, X5)
Two 9-pin D-Sub female connectors are used
for the serial interfaces UART”A” and UART”B”.
TXD is the transmit output, RXD is the receive input.
The DTR or RTS signal can be used to generate a reset.
Please use 1:1 cable for PC-connection.
Note: UART”B” (X5) is only available within
MB90895 Series, MB90360, and MB90960 Series.
© Fujitsu Microelectronics Europe GmbH
X2 (25 – 48)
Connector
X1 (1 – 24)
Centre is connected to ground (GND)
Chapter 5 Connectors
MCU Pins
Shield is connected to positive voltage supply
(+)
FLASH-CAN-48P
25 – 48
1 – 24
- 23 -
5
9
GND DTR RxD TxD
Connector X3, X5:
CTS RTS DSR
UG-900002-19
1
6