CPMC-88-2 MCM, CPMC-88-2 Datasheet - Page 236

• Manufacturer Part Number: CPMC-88-2
• Description: RF/Coaxial Connector
• Manufacturer: MCM

Specifications of CPMC-88-2

• Connector Type: BNC Coaxial

236
Assembly Instructions
INCHES (MILLIMETERS) • CUSTOMER DRAWINGS AVAILABLE ON REQUEST
SMB 3-Piece
Straight Plugs
Connectivity Solutions
Tel: [phone]
•
Fax: [phone]
1. Identify connector parts. (3 piece parts): Crimp sleeve,
2. Strip cable to dimensions shown. Do not nick braid or
3. Assemble contact onto cable as shown.
4. Flare braid and slide body assembly over contact and
RG-316/U, 161, 174,
179, 187, 188
RG-316 DS, 188 DS,
RG-58/U, 141, 303
RG-179/U, 187
RG-179 DS, 187 DS
Belden 735A
body assembly and contact
center conductor. Tin center conductor if contact will be
solder attached. Do not tin center conductor if contact is
to be crimp attached. Slide heat shrink (as applicable)
and crimp sleeve onto jacket of cable.
Solder Attachment: Solder contact to center conductor
through solder hole using .015 (0.38) diameter solder.
Use a minimum amount of solder for a good joint.
Crimp Attachment: A miniature 8 indent crimp tool
140-0000-970 is recommended. Crimp location should
be centered between end of contact and X-hole using
positioner 140-0000-971. Crimp attachment to solid center
conductor cables is not recommended.
under braid. Then seat body assembly firmly onto contact.
The cable may have to be held in a clamping fixture.
Arrange braid uniformly around crimp stem. Slide crimp
sleeve forward and crimp using recommended crimp tool.
Slide heat shrink forward and shrink (as applicable).
CABLE GROUP
179 DS
•
www.EmersonNetworkPower.com/connectivity
131-3403-021/026
131-3404-021/026
131-3407-011/016
131-8433-001/006
131-8434-001/006
131-8445-011/016
PART NO.
CRIMP HEX
.151 (3.83)
.213 (5.41)
.128 (3.25)
.151 (3.83)
.178 (4.52)
.128 (3.25)