CPMC-88-2 MCM, CPMC-88-2 Datasheet - Page 241

• Manufacturer Part Number: CPMC-88-2
• Description: RF/Coaxial Connector
• Manufacturer: MCM

Specifications of CPMC-88-2

• Connector Type: BNC Coaxial

N Crimp Type Bulkhead Jack
for Flexible Cable
Connectivity Solutions
Tel: [phone]
•
Fax: [phone]
Assembly Instructions
1. Identify connector parts. (6 piece parts)
2. Strip cable to dimensions shown. Do not nick braid or
3. Flare body and slide cable into crimp stem of rear body
4. Arrange braid uniformly around crimp stem. Slide crimp
•
center conductor. A wire stripper of correct size is
recommended for this step. Twist stranded center
conductor into a tight bundle and tin (optional). Slide
crimp sleeve onto cable as shown.
subassembly, until cable dielectric bottoms out on center
contact. Solder center conductor to contact through the
solder hole. Solder must not be allowed to gather and
run on outside of contact. Use a minimum amount of
solder for a good joint. .020 (0.51) diameter solder is
recommended.
sleeve over braid and crimp securely using
recommended crimp tool. Slide insulator over center
conductor and slide center contact assembly into
connector body. Thread rear body subassembly into body
and tighten securely (ref. 30 in-lbs torque.)
www.EmersonNetworkPower.com/connectivity
INCHES (MILLIMETERS) • CUSTOMER DRAWINGS AVAILABLE ON REQUEST
RG-316/U, 161, 174, 188 134-0303-406 .160 (4.06)
RG-55/U, 142, 223, 400 134-0308-406 .213 (5.41)
RG-316 DS, 188 DS
RG-58/U, 141, 303
GROUP
CABLE
134-0304-406 .160 (4.06)
134-0307-406 .213 (5.41)
PART
NO.
CRIMP
HEX
241