LPC2378-STK-MICTOR Olimex Ltd., LPC2378-STK-MICTOR Datasheet - Page 2

• Manufacturer Part Number: LPC2378-STK-MICTOR
• Description: MCU, MPU & DSP Development Tools DEV BRD FOR LPC2378
• Manufacturer: Olimex Ltd.

Specifications of LPC2378-STK-MICTOR

• Processor To Be Evaluated: LPC2378
• Data Bus Width: 16 bit, 32 bit
• Interface Type: RS-232, Ethernet, CAN, I2C, JTAG, SPI, UART
• Dimensions: 5.3 in x 3.99 in
• Operating Supply Voltage: 3.3 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

INTRODUCTION:
BOARD FEATURES:
ELECTROSTATIC WARNING:
BOARD USE REQUIREMENTS:
LPC-2378STK is a starter kit which uses Microcontroller LPC2378 from NXP. This
microcontroller supports various serial interfaces such as USB 2.0, UART, CAN, etc.
In addition you will find also audio input and output, JTAG, Ethernet, TFT display
and SD/MMC card holder on this board. All this along allow you to build a diversity
of powerful applications to be used in a wide range of situations.
The LPC-2378STK board is shipped in protective anti-static packaging. The board
must not be subject to high electrostatic potentials. General practice for working with
static sensitive devices should be applied when working with this board.
Cables:
MCU: LPC2378 16/32 bit ARM7TDMI-S™t with 512K Bytes Program Flash, 16K
Bytes RAM, EXTERNAL MEMORY BUS, RTC, 4x 10 bit ADC 2.44 uS, 2x UARTs,
4x CAN, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up
to 60MHz operation
standard
programming/debugging with ARM-JTAG
Optional - TRACE connector
128x128 pixel 12 bit color TFT LCD with backlight
Ethernet 100MBit
MMA7620 3 axis accelerometer
Two RS232 port
Two CAN drivers and connector
SD/MMC card connector
UEXT connector with I2C, SPI, RS232 and power supply for connecting add-on
modules like RF link, MP3, etc available from Olimex
IrDA transceiver on board
Audio in and Audio Out jacks for microphone and headphones
trimpot connected to ADC
RESET circuit with external control of Philips ISP utility via RS232 port
Jumpers for ISP/RUN mode
Joystick with four directions and push action
two USER button
RESET Button
two on board voltage regulators 3V and 5V with up to 800mA current
Extension port connector for many of microcontrollers pins
single power supply: External power supply, USB or JTAG connector
Battery holder and connector for the RTC
power supply led
FR-4, 1.5 mm, red soldermask, component print
Dimensions: 134.60 x 101.27mm (5.3x3.99")
You will need different cables depending on the used
programming/debugging tool. If you use Olimex's ARM-JTAG, you
will need a LPT cable. If you use ARM-USB-OCD or ARM-USB-TINY,
JTAG
connector
Page 2
with
ARM
2x10
pin
layout
for