LPC2378-STK-MICTOR Olimex Ltd., LPC2378-STK-MICTOR Datasheet - Page 3

• Manufacturer Part Number: LPC2378-STK-MICTOR
• Description: MCU, MPU & DSP Development Tools DEV BRD FOR LPC2378
• Manufacturer: Olimex Ltd.

Specifications of LPC2378-STK-MICTOR

• Processor To Be Evaluated: LPC2378
• Data Bus Width: 16 bit, 32 bit
• Interface Type: RS-232, Ethernet, CAN, I2C, JTAG, SPI, UART
• Dimensions: 5.3 in x 3.99 in
• Operating Supply Voltage: 3.3 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PROCESSOR FEATURES:
Hardware:
Software:
LPC-2378STK board use microcontroller LPC2378 from NXP with these features:
–
–
(ISP) and In-Application Programming (IAP) capabilities. Flash program memory is
on the ARM local bus for high performance CPU access.
–
–
SRAM.
–
–
simultaneous Ethernet DMA, USB DMA, and program execution from on-chip flash
with no contention between those functions. A bus bridge allows the Ethernet DMA
to access the other AHB subsystem.
–
off-chip memory mapped peripherals.
–
interrupts.
–
SSP serial interfaces, the I2S port, and the Secure Digital/MultiMediaCard
(SD/MMC) card port, as well as for memory-to-memory transfers.
–
on an independent AHB bus.
controller.
control I/O, one with IrDA support, all with FIFO.
•
•
•
ARM7TDMI-S processor, running at up to 72 MHz.
Up to 512 kB on-chip flash program memory with In-System Programming
32 kB of SRAM on the ARM local bus for high performance CPU access.
16 kB SRAM for Ethernet interface. Can also be used as general purpose
8 kB SRAM for general purpose DMA use also accessible by the USB.
Dual Advanced High-performance Bus (AHB) system that provides for
EMC provides support for static devices such as flash and SRAM as well as
Advanced Vectored Interrupt Controller (VIC), supporting up to 32 vectored
General Purpose AHB DMA controller (GPDMA) that can be used with the
Serial Interfaces:
you will need USB A-B cable. If you use a software programmer such
as FlashMagic, you may need RS232 or other cables.
Programmer/Debugger – ARM-JTAG, ARM-USB-TINY or ARM-
USB-OCD or other compatible programming/debugging tool.
You can use GCC or other commercial ARM compiler.
Ethernet MAC with associated DMA controller. These functions reside
USB 2.0 full-speed device with on-chip PHY and associated DMA
Four UARTs with fractional baud rate generation, one with modem
Page 3