LPC2378-STK-MICTOR Olimex Ltd., LPC2378-STK-MICTOR Datasheet - Page 4
![MCU, MPU & DSP Development Tools DEV BRD FOR LPC2378](/photos/26/88/268873/inhouse_lpc2378-stkmictor_t_sml.jpg)
LPC2378-STK-MICTOR
Manufacturer Part Number
LPC2378-STK-MICTOR
Description
MCU, MPU & DSP Development Tools DEV BRD FOR LPC2378
Manufacturer
Olimex Ltd.
Datasheet
1.LPC2378-STK-MICTOR.pdf
(23 pages)
Specifications of LPC2378-STK-MICTOR
Processor To Be Evaluated
LPC2378
Data Bus Width
16 bit, 32 bit
Interface Type
RS-232, Ethernet, CAN, I2C, JTAG, SPI, UART
Dimensions
5.3 in x 3.99 in
Operating Supply Voltage
3.3 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
LPC2378-STK-MICTOR
Manufacturer:
Olimex Ltd.
Quantity:
135
–
–
–
–
–
–
on PORT0 and PORT2 can be used as edge sensitive interrupt sources.
an alternate for the SPI port, sharing its interrupt and pins. These can be used
with the GPDMA controller.
port pins).
used with the GPDMA.
resistors.
compare outputs. Each timer block has an external count input.
The PWM has two external count inputs.
the RTC oscillator or the APB clock.
stored when the rest of the chip is powered off.
RC oscillator, the RTC oscillator, or the APB clock.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Other peripherals:
Standard ARM test/debug interface for compatibility with existing tools.
Emulation trace module supports real-time trace.
Single 3.3 V power supply (3.0 V to 3.6 V).
Four reduced power modes: idle, sleep, power down, and deep power down.
Four external interrupt inputs configurable as edge/level sensitive. All pins
CAN controller with two channels.
SPI controller.
Two SSP controllers, with FIFO and multi-protocol capabilities. One is
Three I2C-bus interfaces (one with open-drain and two with standard
I
SD/MMC memory card interface.
104 General purpose I/O pins with configurable pull-up/down
10-bit ADC with input multiplexing among 8 pins.
10-bit DAC.
Four general purpose timers/counters with 8 capture inputs and 10
One PWM/timer block with support for three-phase motor control.
Real-Time Clock (RTC) with separate power pin, clock source can be
2 kB SRAM powered from the RTC power pin, allowing data to be
WatchDog Timer (WDT). The WDT can be clocked from the internal
2
S (Inter-IC Sound) interface for digital audio input or output. It can be
Page 4