DRT2-MD16S Omron, DRT2-MD16S Datasheet - Page 47

• Manufacturer Part Number: DRT2-MD16S
• Description: DRT2 Mix IO E-Con8 In/out, NPN
• Manufacturer: Omron

Specifications of DRT2-MD16S

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Setting and Wiring Hardware
2-3-3
2-3-4
Connecting
Communications
Cables
Wiring the I/O Power
Supply
Wiring I/O
26
Mounting Connecting Devices
Connecting Cables
1,2,3...
Remote I/O
Terminal
Remote I/O
Terminal
The following connecting devices require being mounted:
Connect the Master Unit and T-branch Taps, T-branch Taps and T-branch
Taps, and T-branch Taps and Slaves using Thin DeviceNet Communications
Cables, as shown in the following diagram.
Use the following procedure to connect the cables. Refer to 5-2 Connecting
Communications Cables to General-purpose Slaves for details.
1. Prepare the communications cables and attach the connectors to the ca-
2. Connect the communications cable connectors to the node connectors on
If required, an I/O power supply for I/O devices is connected to the Remote
I/O Terminals. Connect M3 crimp terminals to the power lines and then con-
nect them to the terminal block.
Wire the I/O to the Remote I/O Terminals.
Connect M3 crimp terminals to the signal lines and then connect them to the
terminal block.
Terminating
Resistor
• T-branch Taps: Secure to the control panel with screws, or mount to a DIN
• Terminal-block Terminating Resistors: Secure to the control panel with
Track.
screws.
bles.
the Master Unit, T-branch Taps, and Slaves.
CS Rack
If a Terminal-block Terminating Resistor is required, connect it to
the end of an extension cable (1 m max.) that is connected to the
final node.
T-branch
Tap
When a Terminating Resistor is required, connect it to the
final T-branch Tap in the Network. The T-branch Tap must
be no further than 6 m from the final node.
Remote I/O
Terminal
24-V DC power
supply
T-branch
Tap
T-branch
Tap
Section 2-3
Remote I/O
Terminal