NT631C-ST153-EV3 Omron, NT631C-ST153-EV3 Datasheet - Page 40

• Manufacturer Part Number: NT631C-ST153-EV3
• Description: 10.48-ColrDisplay,TFT,Ivy,Eng
• Manufacturer: Omron

Specifications of NT631C-ST153-EV3

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

NT31/NT31C, NT631/
NT631C
System Installer
Support Tool
1-6
Before Operating
Device or Software
Before Operating
Reference:
Create the host program.
Set the host settings.
• For the host link, refer to
• For the NT link (1:1), refer
• For the NT link (1:N), refer
• For the high-speed NT
• For the Memory link, refer
Connect to the
NT631/NT631C.
pages 48 and 94, and the
manuals for the Host Link
Unit and Programming
Devices.
to pages 61 and 106.
to pages 65 and 108.
link (1:N), refer to pages
70 and 112.
to pages 73 and 114.
Host
Reference Manual
NT-series Support Tool for Windows (Ver. 4.@) Operation Manual
NT-series Support Tool for Windows (Ver. 4.@) Operation Manual
Follow the procedure given below to start the system of the NT631/NT631C.
*1
*2
Refer to the following manuals for the devices and software.
System program installation is only done in special circumstances, for
example when changing the system program, or to recover the original sta-
tus of the installed program. This operation is not normally necessary.
When using other PLC models (sequencers), however, it is necessary to
install specific system programs.
Display of the system menu, and all change operations, can be inhibited.
This enables you to prevent the accidental deletion or alteration of screens
and settings.
• For the system program, use the NT631/NT631C system program sup-
• For the Support Tool, use NT-series Support Tool for Windows (Ver. 4.@).
Start operation.
plied as an accessory with the NT-series Support Tool (NT-ZJCAT1-EV4).
Install the system program.
Connect the power supply.
Set the memory switches.
Make the settings in the
system installer mode.
Confirm the settings and
check communications.
Install the PT in the
operation panel.
Connect to the host.
(page 32)
(page 152)
(page 33)
(page 144)
(Refer to page 145 and the
Support Tool manual)
When RS-232C used at the PT: refer to section 4
When RS-422A/485 used at the PT: refer to section 5
NT631/NT631C
Manual Title
Transmit the screen data.
*2
*1
Install the Support
Tool at the computer.
Create the screens.
(Refer to the NT31/NT31C/NT631/NT631C
Programmable Terminal Reference Manual
and the Support Tool Operation Manual.)
(Refer to the manual for
the Support Tool.)
(page 149)
Support Tool
V064-E1-1
V061-E1-@
V061-E1-@
Manual Number
Section 1-6
23