M4SARC OPTO 22, M4SARC Datasheet
![Computers, Interface Cards](/photos/21/57/215775/4085212_sml.jpg)
M4SARC
Specifications of M4SARC
Related parts for M4SARC
M4SARC Summary of contents
Page 1
... Opto 22 controllers can be linked to a single PC, allowing a user to build large distributed control systems. Using Opto 22 M4SARC, M4DUALARC, M4SARCF, and M4SARCFR ARCNET interface cards, plus the appropriate PC and active hub equipment, you can construct an extensive network of coaxial, twisted-pair, and fiber optic ARCNET for Opto 22 controllers ...
Page 2
... Mbps, consider using an Ethernet network and Opto 22’s M4SENET-100 interface card.) Using commercial hubs and repeaters, an ARCNET network of virtually any size can be created. Software The M4SARC interface card is designed to work with FactoryFloor, Opto 22’s powerful suite of 32-bit industrial Specifications Item ...
Page 3
... The M4SARC interface card itself has built-in termination and does not need to be terminated. Note: Do not install a terminating jumper on the TERM jumper on the M4SARC card. This jumper is not used, and the interface card will not operate if this jumper is terminated. CONTROLLERS MODULAR ...
Page 4
... To correctly align the interface card, you may need to remove additional end caps from the controller. 4. Align the edges of the M4SARC card with the U-channels on the sides of the selected expansion slot, and then slide the card in until it is seated firmly in the M4BUS connector ...
Page 5
... Opto 22. All rights reserved. All trademarks, trade names, logos, and service marks referenced herein belong to their respective companies. INTERFACES CONTROLLERS MODULAR 4. Align the edges of the M4SARC card with the U-channels on the sides of the selected expansion slot, and then slide the card in until it is seated firmly in the M4BUS connector. ...
Page 6
... M4DUALARC twisted-pair card are both installed in a controller (with host port jumpers set for ARCNET), the coaxial ARCNET port on the M4SARC card will be the host port because it has the lowest ARCNET port number (4 M4-family controller has jumper settings configured for ARCNET, but an ARCNET card is not installed, COM0 will be the host port by default ...
Page 7
... Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • Phone: (951) 695-3000 • (800) 321-OPTO • Fax: (951) 695-3095 • www.opto22.com Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • Phone: (951) 695-3000 • (800) 321-OPTO • Fax: (951) 695-3095 • www.opto22.com Inside Sales: (800) 321-OPTO • ...