M4SARC OPTO 22, M4SARC Datasheet - Page 4

• Manufacturer Part Number: M4SARC
• Description: Computers, Interface Cards
• Manufacturer: OPTO 22

Specifications of M4SARC

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

DATA SHEET
Form 631-040823
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • Phone: [phone] • (800) 321-OPTO • Fax: [phone] • www.opto22.com
Installation (continued)
Inserting the Card in an M4-Family
Controller (except SNAP-LCM4)
1. Turn off the controller.
2. Select an unused M4BUS expansion slot and remove
© 2004 Opto 22. All rights reserved. All trademarks, trade names, logos, and service marks referenced herein belong to their respective companies.
Inside Sales: (800) 321-OPTO • Product Support: (800) TEK-OPTO • [phone] • Fax: [phone] • Email: [e-mail]
the end cap. End caps are located below the serial
connectors, as shown in the illustration below.
on the side panel, adjacent to each end cap. Save these
Each end cap is held in place by two screws located
M4RTU Controller
4. Align the edges of the M4SARC card with the
5. Use the screws from the original end cap to attach the
screws after you remove them. To correctly align the
interface card, you may need to remove additional end
caps from the controller.
U-channels on the sides of the selected expansion slot,
and then slide the card in until it is seated firmly in the
M4BUS connector.
included M4SARC end cap to the M4-family controller.
INTERFACES
CONTROLLERS
MODULAR
page 4/7