M4SARC OPTO 22, M4SARC Datasheet - Page 5

• Manufacturer Part Number: M4SARC
• Description: Computers, Interface Cards
• Manufacturer: OPTO 22

Specifications of M4SARC

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

DATA SHEET
Form 631-040823
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • Phone: [phone] • (800) 321-OPTO • Fax: [phone] • www.opto22.com
Inserting the Card in a SNAP-LCM4
Controller
Installation (continued)
1. Turn off the controller.
2. Select an unused M4BUS expansion slot and remove
© 2004 Opto 22. All rights reserved. All trademarks, trade names, logos, and service marks referenced herein belong to their respective companies.
Inside Sales: (800) 321-OPTO • Product Support: (800) TEK-OPTO • [phone] • Fax: [phone] • Email: [e-mail]
the cover plate. Cover plates are located to the left of
the serial connectors on the top of the SNAP-LCM4, as
shown in the illustration below. Each cover plate is held
in place by two thumbscrews. Save these thumbscrews
after you remove them.
SNAP-LCM4 Controller
4. Align the edges of the M4SARC card with the
5. Use the thumbscrews from the original cover plate to
U-channels on the sides of the selected expansion slot,
and then slide the card in until it is seated firmly in the
M4BUS connector.
attach the included M4SARC cover plate to the
SNAP-LCM4 controller.
INTERFACES
CONTROLLERS
MODULAR
page 5/7