ATA5823-PLQW80 Atmel, ATA5823-PLQW80 Datasheet - Page 66

• Manufacturer Part Number: ATA5823-PLQW80
• Description: RF Transceiver RF Data Control Duplex Transceiver
• Manufacturer: Atmel

Specifications of ATA5823-PLQW80

• Output Power: 10 dBm
• Operating Supply Voltage: 2.15 V to 3.6 V
• Maximum Operating Temperature: + 105 C
• Mounting Style: SMD/SMT
• Package / Case: QFN-48
• Minimum Operating Temperature: - 40 C
• Modulation: ASK, FSK
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

66
ATA5823/ATA5824
The timing of the FD mode is illustrated in
place if the FD mode is enabled in the slave before it is enabled in the master. If the FD mode is
enabled in the master before it is enabled in the slave, a maximum delay T
proper operation. T
during the Bit-check. This is calculated as follows:
T
Table 14-7.
This means, to get a extended time period for enabling the FD mode, increase the preburst
length in the master and reduce N
sampling edge (pin SCK) for the LSB while writing control register 1.
For a proper operation in the slave, a wake-up due to noise must be prevent (bit check + start bit
ok). To achieve this for the slave the following adjustments are recommended:
FD_sync
1. Set N
2. Start FD mode in master and slave as simultaneously as possible.
< T
BIT-check
Preburst
T
Bit-check-min
6 (recommended)
- T
FD_sync
N
6
Startup-sig-proc-fd
Bit-check
3
9
depends on the preburst length and the number of bits to be checked
- T
Bit-check
Bit-check-min
Figure 14-13 on page
in the slave. The reference points for T
67. A proper data transfer takes
10
4
7
T
Bit-check-min
168
168
168
FD_sync
T
T
T
DCLK
DCLK
DCLK
is allowed for a
FD_sync
4829D–RKE–06/06
are the