NP8P128A13T1760E Micron Technology Inc, NP8P128A13T1760E Datasheet - Page 53
![no-image](/images/manufacturer_photos/0/4/441/micron_technology_inc_sml.jpg)
NP8P128A13T1760E
Manufacturer Part Number
NP8P128A13T1760E
Description
Manufacturer
Micron Technology Inc
Datasheet
1.NP8P128A13T1760E.pdf
(94 pages)
Specifications of NP8P128A13T1760E
Lead Free Status / RoHS Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
NP8P128A13T1760E
Manufacturer:
TI
Quantity:
1 043
Company:
Part Number:
NP8P128A13T1760E
Manufacturer:
Micron Technology Inc
Quantity:
10 000
Numonyx® Omneo™ P8P Datasheet
12.4.8
Note:
August 2010
316144-07
Page program (PP)
This definition applies to all flavors of Page Program: Legacy Program, Bit-alterable.
The page program (PP) instruction allows bytes to be programmed/written in the
memory. Before it can be accepted, a write enable (WREN) instruction must previously
have been executed. After the write enable (WREN) instruction has been decoded, the
device sets the write enable latch (WEL).
The page program (PP) instruction is entered by driving Chip Select (S#) Low, followed
by the instruction code, three address bytes and at least one data byte on serial data
input (DQ0). If the 6 least significant address bits (A5-A0) are not all zero, all
transmitted data that goes beyond the end of the current page are programmed from
the start address of the same page (from the address whose 6 least significant bits
(A5-A0) are all zero). Chip Select (S#) must be driven Low for the entire duration of
the sequence.
If more than 64 bytes are sent to the device, previously latched data are discarded and
the last 64 data bytes are guaranteed to be programmed/written correctly within the
same page. If less than 64 data bytes are sent to device, they are correctly
programmed/written at the requested addresses without having any effects on the
other bytes of the same page. (With Program on all 1s, the entire page should already
have been set to all 1s (FFh).)
For optimized timings, it is recommended to use the page program (PP) instruction to
program all consecutive targeted bytes in a single sequence versus using several page
program (PP) sequences with each containing only a few bytes.
Chip Select (S#) must be driven High after the eighth bit of the last data byte has been
latched in, otherwise the page program (PP) instruction is not executed.
As soon as Chip Select (S#) is driven High, the self-timed page program cycle (whose
duration is t
register may be read to check the value of the write in progress (WIP) bit. The write in
progress (WIP) bit is 1 during the self-timed page program cycle, and is 0 when it is
completed. At some unspecified time before the cycle is completed, the write enable
latch (WEL) bit is reset. RDSR is the only instruction accepted while a Page Program
operation is in progress; all other instructions are ignored.
PP
) is initiated. While the page program cycle is in progress, the status
53