5962-8751410XA QP SEMICONDUCTOR, 5962-8751410XA Datasheet - Page 23

• Manufacturer Part Number: 5962-8751410XA
• Manufacturer: QP SEMICONDUCTOR

Specifications of 5962-8751410XA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
out the required byte write time and at the end of this time, the device signals the RDY/BUSY pin to a TTL high. The
RDY/BUSY pin is an open drain output and a typical 3 kΩ pull-up resistor to V
dependent on the number of OR-tied RDY/BUSY pins (applies to device types 13 through 17 and 23 through 28).
inadvertent writes. These devices are placed in protected state by writing a series of instructions (see figure 9) to the device.
Once protected, writing to the device may only be performed by executing the same sequence of instructions appended with
either a byte write operation or page write operation. The waveforms and timing relationships shown on figures 4 - 8 and the
test conditions and limits specified in table I shall apply.
instructions (see figure 10) to the device. The waveforms and timing relationships shown on figures 4 - 8 and the test
conditions and limits specified in table I shall apply.
(original equipment), design applications, and logistics purposes.
prepared specification or drawing.
the individual documents. This coordination will be accomplished using DD Form 1692, Engineering Change Proposal.
application requires configuration control and the applicable SMD. DSCC will maintain a record of users and this list will be
used for coordination and distribution of changes to the drawings. Users of drawings covering microelectronics devices (FSC
5962) should contact DSCC-VA, telephone [phone].
[phone].
HDBK-103 have agreed to this drawing and a certificate of compliance (see 3.6 herein) has been submitted to and accepted
by DSCC-VA.
4.4.3 RDY/BUSY. While the write operation is in progress, the RDY/BUSY output is at a TTL low. An internal timer times
4.4.4 Set software data protection. Device types 01-05 and 08-12 software data protection offers a method of preventing
4.4.4.1 Reset software data protection. Device types 01-05 and 08-12 protection feature is reset by writing a series of
5. PACKAGING
5.1 Packaging requirements. The requirements for packaging shall be in accordance with MIL-PRF-38535, appendix A.
6. NOTES
6.1 Intended use. Microcircuits conforming to this drawing are intended for use for Government microcircuit applications
6.2 Replaceability. Microcircuits covered by this drawing will replace the same generic device covered by a contractor-
6.3 Configuration control of SMD's. All proposed changes to existing SMD's will be coordinated with the users of record for
6.4 Record of users. Military and industrial users shall inform Defense Supply Center Columbus (DSCC) when a system
6.5 Comments. Comments on this drawing should be directed to DSCC-VA, Columbus, Ohio 43218-3990, or telephone
6.6 Approved sources of supply. Approved sources of supply are listed in MIL-HDBK-103. The vendors listed in MIL-
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43218-3990
STANDARD
SIZE
A
CC
is required. The pull-up resistor value is
REVISION LEVEL
F
SHEET
5962-87514
23