101-0412 Rabbit Semiconductor, 101-0412 Datasheet - Page 68

• Manufacturer Part Number: 101-0412
• Description: INTERFACE PROG 12KEY DISP OP6700
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0412

• Module/board Type: Single Board Computer Module
• For Use With/related Products: OP6700
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

B.2.1 Assembling Intellicom Enclosure
There are two recommended assemblies possible for the Intellicom:
1. Mount the front panel bezel in an opening you have created. This option allows you to
2. Mount the front panel bezel using the outer casing supplied with the Intellicom.
B.2.1.1 Custom Mounting In An Opening
Place the rubber gasket supplied with the Intellicom between the front panel bezel and the
surface the Intellicom will be mounted. A splash-resistant seal will result when the brack-
ets are attached.
64
Prepare an opening to accommodate the Intelli-
com front panel bezel shown in Figure B-4. The
thickness of the surface the Intellicom front bezel
is mounted on should be either 0.0625 inches
(1.6 mm) or 0.125 inches (3.2 mm). Use the
brackets on the plastic tree included with the Intel-
licom (see Figure B-6) to attach the front panel
bezel to the surface.
A splash-resistant mounting is also possible.
First, remove the speaker from the front panel
bezel, and insert the speaker plug to close the
holes in the speaker grille. Apply some hot glue
around the edges of the plug to form a splash-
resistant seal. Replace the speaker—a dab of glue
around the edge of the speaker will hold it in place.
have a splash-resistant unit by using the gasket supplied with the Intellicom to form a
splash-resistant seal between the front panel bezel and your opening.
Figure B-7. Splash-Resistant Mounting of Intellicom
Figure B-6. Mounting Brackets and
Speaker Plug
Intellicom (OP6600/OP6700)