101-0412 Rabbit Semiconductor, 101-0412 Datasheet - Page 80

• Manufacturer Part Number: 101-0412
• Description: INTERFACE PROG 12KEY DISP OP6700
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0412

• Module/board Type: Single Board Computer Module
• For Use With/related Products: OP6700
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

• A message reports “No Rabbit Processor Detected” in cases where the wall transformer
• The programming cable must be connected to the Intellicom board. (The colored wire
• To check if you have the correct serial port, select
D.2.1 Single-Stepping
Compile or re-compile
program will compile and the screen will come up with a highlighted character (green) at
the first executable statement of the program. Use the
F8
j< ...
to press
D.2.1.1 Watch Expression
Type
come up. Type the lower case letter j and click on add to top and close. Now continue sin-
gle-stepping with
printed in the watch window. Note how the value of
executed.
D.2.1.2 Break Point
Move the cursor to the start of the statement:
To set a break point on this statement, type
red highlight will appear on the first character of the statement. To get the program run-
ning at full speed, type
it hits the break point. The break point will start flashing both red and green colors. Note
that LED1 on the Demonstration Board is now solidly turned on. This is because we have
passed the statement turning on LED1.
To remove the break point, type
continue program execution, type
should be flashing again because the program is running at full speed.
You can set break points while the program is running by positioning the cursor to a state-
ment and using the
76
is either not connected or is not plugged in.
on the programming cable is closest to pin 1 on header J4 on the Intellicom board, as
shown in Figure 1.) The other end of the programming cable must be connected to the
PC serial port. The COM port specified in the Dynamic C
same as the one the programming cable is connected to.
type
different serial port using the Dynamic C
you are plugged into. Don’t change anything in this menu except the COM number.
The baud rate should be 115,200 bps and the stop bits should be 1.
key is pressed, the cursor will advance one statement. When you get to the
<ctrl-W>
<ctrl-Y>
F8
statement, it becomes impractical to single-step further because you would have
for(j=0; j<20000; j++);
thousands of times. We will use this statement to illustrate watch expressions.
or chose
. If the “BIOS successfully compiled …” message does not display, try a
F8
F2
. Each time you step, the watch expression (
key. If the execution thread hits the break point, a break point will
F9
DEMOBRD1.C
Add/Del Watch Expression
or select
F2
F9
Run
or select
or select
by clicking the
on the
F2
Options
Toggle Breakpoint
or select
Run
Run
from the
menu. The program will advance until
j
Compile
Compile
in the
menu until you find the serial port
F8
advances when the statement
Breakpoint
key to single-step. Each time the
Inspect
Run
Options
, then
button on the task bar. The
j
on the
Intellicom (OP6600/OP6700)
menu. Now LED1
) will be evaluated and
from the
menu. A box will
Compile BIOS
menu must be the
Run
Run
menu. To
for(j=0,
menu. A
j++
, or
is