UDA1355H/N2,557 NXP Semiconductors, UDA1355H/N2,557 Datasheet - Page 38

• Manufacturer Part Number: UDA1355H/N2,557
• Description: IC CODEC STER/SUDIO SPDIF 44QFP
• Manufacturer: NXP Semiconductors
• Type: Stereo Audior

Specifications of UDA1355H/N2,557

• Data Interface: I²C, Serial
• Resolution (bits): 24 b
• Number Of Adcs / Dacs: 2 / 2
• Sigma Delta: No
• S/n Ratio, Adcs / Dacs (db) Typ: 97 / 98
• Voltage - Supply, Analog: 2.7 V ~ 5.5 V
• Voltage - Supply, Digital: 2.7 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 44-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 935271552557

11.10 Read cycle
The read cycle is used to read the data values from the internal registers. The I
The format of the read cycle is as follows:
1. The microcontroller starts with a start condition (S).
2. The first byte (8 bits) contains the device address 0011010 and a logic 0 (write) for the R/W bit.
3. This is followed by an acknowledge (A) from the UDA1355H.
4. After this microcontroller writes the 8-bit register address (ADDR) where the reading of the register content of the UDA1355H must start.
5. The UDA1355H acknowledges this register address (A).
6. Then the microcontroller generates a repeated start (Sr).
7. Then the microcontroller generates the device address 0011010 again, but this time followed by a logic 1 (read) of the R/W bit. An acknowledge (A)
8. The UDA1355H sends two bytes data with the Most Significant (MS) byte first and then the Least Significant (LS) byte. After each byte an
9. If repeated groups of two bytes are transmitted, then the register address is auto incremented. After each byte an acknowledge follows from the
10. The microcontroller stops this cycle by generating a Negative Acknowledge (NA).
11. Finally, the UDA1355H frees the I
Table 23 Master transmitter reads from the UDA1355H registers in the I
Note
1. Auto increment of register address.
S
follows from the UDA1355H.
acknowledged follows from the microcontroller.
microcontroller.
ADDRESS
0011010
DEVICE
R/W
0
acknowledge from UDA1355H
A
REGISTER
ADDRESS
ADDR
2
C-bus and the microcontroller can generate a stop condition (P).
A
Sr
ADDRESS
DEVICE
0011010
2
C-bus mode
R/W
1
2
C-bus configuration for a read cycle is shown in Table 23
A
MS1 A LS1
DATA 1
A ... A ... A MSn A
acknowledge from master
DATA 2
(1)
DATA n
LSn
(1)
NA
P