R88A-CAWE010B Omron, R88A-CAWE010B Datasheet - Page 267
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
R88A-CAWE010B
Manufacturer Part Number
R88A-CAWE010B
Description
POWER CABLE W/BRAKE 10M
Manufacturer
Omron
Datasheet
1.R88A-TK02W.pdf
(479 pages)
Specifications of R88A-CAWE010B
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
R88ACAWE010B
- Current page: 267 of 479
- Download datasheet (5Mb)
Operation
D Operation Procedure
Note When connecting a Servomotor with an absolute encoder and turning ON the power for the first
D Turn ON the Power
H Additional Setup Operations
D Trial Operation Setup
Note The number of rotations and the output range for the OMNUC W-series absolute encoders are
(Approx. 1 s later)
• The preceding setup is necessary to check the Servomotor and Servo Driver operations (without a
• When connecting to the CV500-MC221/421 or C200H-MC221 Motion Control Unit, carry out the set-
operation
PR02W
The alarm (A.81) will not be cancelled with the setup operation. Turn OFF the power (and check that
the power indicator is not lit), then turn ON the power again to cancel the alarm. After the power is
turned ON again, as long as there is no error, the setup procedure is complete at this point. If an alarm
(A.81) occurs, repeat the previous step.
load). When connecting the Servomotor and mechanical system for a trial operation, the absolute
encoder may rotate excessively. If that occurs, perform the setup once again.
up close to the mechanical origin. An error will be generated if the absolute data exceeds ±32,767
pulses when making the initial settings for the CV500-MC221/MC421 or C200H-MC221 Motion
Control Unit (This limitation does not apply to the CS1W-MC221/MC241 Motion Control Unit).
Set the operating range within the number of rotations and output range.
W series:
U series:
time, A.81 (backup error) will be displayed.
different from the previous models (U series).
key operation
Front panel
(1 s min.)
(1 s min.)
Number of rotations and output range: –32,768 to 32,767
Number of rotations and output range: –99,999 to 99,999
Display example
Status Display Mode. (See note.)
Press the MODE/SET Key to change to System Check
Mode.
Press the Up or Down Key to select function Fn008.
Press the DATA Key (front panel: DATA Key for 1 s min.)
to enter the absolute encoder setup functions. PGCL1
will be displayed.
Press the Up Key to display PGCL5.
Press the MODE/SET Key to set up the absolute
encoder. When setup is complete, “donE” will flash for
approximately 1 s.
After “donE” has been displayed, the display will return
to “PGCL5.”
Press the DATA Key (front panel: DATA Key for 1 s min.)
to display the System Check Mode function code.
Explanation
Chapter 4
4-7