NS12-ATT01 Omron, NS12-ATT01 Datasheet - Page 123
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
NS12-ATT01
Manufacturer Part Number
NS12-ATT01
Description
NT625C/NT631/NT631C TO NS10
Manufacturer
Omron
Datasheet
1.NS12-TS01B-V2.pdf
(334 pages)
Specifications of NS12-ATT01
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
NS12ATT01
- Current page: 123 of 334
- Download datasheet (7Mb)
4-2 1:N Host Connection
4-2-1
4-2-2
Connection Methods
Unit Setting Methods
This section describes the methods used to connect multiple PTs to a single host in a 1:N
connection and provides information on the relationship between the connection methods
and the communications methods.
The Host and PTs are connected in a 1:N configuration using RS-422A with an RS-
232C/RS-422A Converter.
This connection method can be used for 1:N NT Link connections (normal, high-speed).
The NS15 does not require an adapter if RS-422A is set for serial port B.
• Supported Host Units
The OMRON PLCs that can be connected in 1:N NT Links are limited to the CS-series, CJ-
series, and C-series PLCs. CS-series PLCs can also be connected in 1:N NT Links by using
a CS1W-SCU21/31 Serial Communications Unit. CJ-series PLCs can also be connected in
1:N NT Links by using a CJ1W-SCU31/41 Serial Communications Unit.
Check the series and model of the PLC and the model of the Board or Unit that is mounted
to the PLC when connecting the PTs to the host.
For details on the Units used as hosts that can be connected in 1:N NT Links, refer to Ap-
pendix 8 Standard Models.
Reference
Host Settings
The methods for setting each Unit are as follows:
Connecting C-series C200HX/HG/HE(-Z), and CQM1H PLCs
PLC Setup Area
Write the settings directly from the Programming Device or Support Software (CX-
Programmer, etc.) to the
used.
PT
NS-AL002
Converter
• NS-series RS-485 (two-wire) communications are used to connect to an OMRON
• CS-series PLCs with -V1 suffix support high-speed 1:N NT Links as well as normal
Temperature Controller. The NS-AL002 cannot be used with the NT-series PTs or PLCs.
Always use RS-422A (four-wire).
1:N NT Links. CS-series PLCs without the -V1 suffix can also be connected to high-
speed 1:N NT Links if the latest Serial Communications Board/Unit is used. Refer to
High-speed 1:N NT Link for details. (page 4-18).
RS-422A cable
PLC
Setup Area (Data Memory) according to the host type and port
Host
4-2 1:N Host Connection
4-7