NS12-ATT01 Omron, NS12-ATT01 Datasheet - Page 282
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
NS12-ATT01
Manufacturer Part Number
NS12-ATT01
Description
NT625C/NT631/NT631C TO NS10
Manufacturer
Omron
Datasheet
1.NS12-TS01B-V2.pdf
(334 pages)
Specifications of NS12-ATT01
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
NS12ATT01
- Current page: 282 of 334
- Download datasheet (7Mb)
Appendix 3 Using NS-AL002 Converters
A-3-2
A-3-3
A-22
Mounting and Removing
Specifications
Connect the NS-AL002 directly to port A or port B of the PT. Two NS-AL002 Adapters
cannot be connected to ports A and B simultaneously.
Mount the Adapter by tightening and securing the mounting screws on both of the D-Sub
connectors. The correct tightening torque is 0.3 N⋅m. The correct tightening torque for the
terminal block is 0.5 N⋅m.
To remove the Adapter, loosen the screws and pull out the Adapter.
The following table shows the general specifications and communications specifications
of the Adapter.
• RS-422A Interface
Note 1: This specification is for a configuration in which all the Adapters connected on the same
Note 2: The RS-422A and RS-232C are not insulated.
Reference
Dimensions
Weight
Ambient operating temperature
Storage temperature
Ambient operating humidity
Rated power supply
Power consumption
Operating environment
Vibration resistance
Shock resistance
Baud rate
Transmission distance
Terminal block format
Insulation
Precautions
for Safe Use
Precautions
for Correct Use
General Specifications
Communications Specifications
transmission path are NT-AL002 Link Adapters. If a CJ1W-CIF11 Conversion Adapter is
used, the total length is 50 m.
Item
NS-series RS-485 (two-wire) communications are used to connect to an OMRON
Temperature Controller. The NS-AL002 cannot be used with the NT-series PTs or
PLCs.
Item
• Always turn OFF the power to the PT before removing the Adapter.
• Do not touch the surface or the mounted parts of the Board with bare hands.
• Mount to the PT after securely connecting the cable to the terminal block.
Always discharge any static electricity from your body before handling the
Board.
the screws are loose, the FG terminals of the PT and NS-AL002 will not be
connected.
Be sure to tighten the mounting screws on both of the D-Sub connectors. If
45 × 49 × 28.5 mm (W × H × D)
50 g max.
0 to 50°C
−20 to 60°C
35% to 85% (without condensation)
5 V ±10% (through pin 6 of the RS-232C connector)
No corrosive gases.
Conforms to PT specifications.
150 mW max.
Conforms to PT specifications.
115.2 kbps max.
500 m total length (See note 1.)
8-terminal terminal block, M3.0
No insulation (See note 2.)
Specifications
Specifications