NS12-ATT01 Omron, NS12-ATT01 Datasheet - Page 15
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
NS12-ATT01
Manufacturer Part Number
NS12-ATT01
Description
NT625C/NT631/NT631C TO NS10
Manufacturer
Omron
Datasheet
1.NS12-TS01B-V2.pdf
(334 pages)
Specifications of NS12-ATT01
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
NS12ATT01
- Current page: 15 of 334
- Download datasheet (7Mb)
26. To ensure safety when using numeral input functions, set the upper and lower limits for the
27. Before initializing screen data, confirm that existing data is backed up at the CX-Designer.
28. When changing the password with the system menu, do not reset or turn OFF the power
29. When using the device monitor, confirm the safety of the system before performing the
30. Dispose of any battery that has been dropped on the floor or otherwise subjected to
31. Do not connect an USB connector to any device that is not applicable.
32. Before connecting an USB connector to a device, make sure that the device is free of
33. Commercially available USB hubs and the recommended USB hub do not necessarily
34. Do not perform the following operations while downloading or uploading screen data or
35. When mounting the Battery, be sure to use the correct Battery and mount it correctly.
36. Do not disassemble or short-circuit the battery.
37. Dispose of the Units and batteries according to local ordinances as they apply.
38. Never use volatile solvents, such as benzene or thinners, or chemical dusters to clean the
39. The backlight in the NS-series PT contains mercury. Do not dispose of the PT together
40. The backlight in the PT cannot be replaced by the user. Contact your OMRON
41.
42.
43. Never connect more than two crimp terminals to one terminal.
44. Water and oil resistance will be lost if the front sheet is torn or is peeling off. Do not use
45. The Rubber Packing will deteriorate, shrink, expand, or harden depending on the
input value.
supply until writing is finished.
following operations.
excessive shock.
damage.
have the same general specifications as the PT, and may not function properly if used in
environments subject to static electricity or other forms of noise. When using a USB hub,
take sufficient measures to prevent static electricity and other forms of noise, or do not
install the PT in an environment subject to such noise.
system program. Doing so may corrupt the screen data or system program.
PT.
with waste to be processed at disposal plants. Dispose of the PT according to all local
laws, regulations, and ordinances.
representative for backlight replacement.
Periodically check the installation conditions in applications where the PT is subject to
contact with oil or water.
The NS15-TX01@-V2 uses an analog touch panel.
touch points to move. If the touch points move too far, calibrate the touch panel.
the PT if the front sheet is torn or is peeling off.
operating environment. Inspect and replace the Rubber Packing periodically.
• Changing monitor data
• Changing operation modes
• Forced setting or resetting
• Changing present values or set values
• Turning OFF the power supply to the PT
• Pressing the PT’s reset switch
Deterioration over time can cause the
13