XW2Z-100J-B9 Omron, XW2Z-100J-B9 Datasheet - Page 33

• Manufacturer Part Number: XW2Z-100J-B9
• Description: SERVO DRV+G8R CONNECTING CABLES
• Manufacturer: Omron

Specifications of XW2Z-100J-B9

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z100JB9

Expanded System Configuration
Host Link System
No-protocol (Custom)
Communications
System via RS-232C
Port
NT Link System
(1:N Mode, Standard)
10
The Host Link System allows the I/O memory of the Modules to be read/writ-
ten and the operating mode to be changed from a host computer (personal
computer or Programmable Terminal (PT)) by executing Host Link commands
or FINS commands that are preceded by a Host Link header and followed by
a terminator. A Host Link System is possible for either the peripheral port or
the RS-232C port on the Coordinator Module.
No-protocol communications allow simple data transmissions, such as input-
ting bar code data and outputting printer data using communications port I/O
instructions TXD(236) and RXD(235). The start and end codes can be set
and, RS and CS signal control is also possible with no-protocol communica-
tions.
If the FQM1 and a Programmable Terminal (PT) are connected together using
the RS-232C port, the allocations for the PT’s status control area, status notify
area, objects such as touch switches, indicators, and memory maps can be
allocated in the I/O memory of the FQM1.
The NT Link System allows the PT to be controlled by the FQM1, and the PT
can periodically read data from the status control area of the FQM1, and per-
form necessary operations if there are any changes in the area. The PT can
communicate with the FQM1 by writing data to the status notify area of the
FQM1 from the PT. The NT Link System allows the PT status to be controlled
and monitored without using FQM1 ladder programming. The ratio of FQM1
Controllers to PTs is 1: n (n ≥ 1).
Host link commands
or FINS commands
embedded in Host Link
commands
Host computer
Coordinator Module
RS-232C
RXD(235) instruction
TXD(236) instruction
RS-232C
Note: Turn ON pin 2 on the DIP switch on the front of the
Note Set the serial communications
Applicable Ports
Coordinator Module and set the serial communications
mode in the System Setup to "Host Link."
Peripheral
Coordinator Module
No
mode in the System Setup to
"non-procedural."
Peripheral port
Yes
(See note.)
RS-232C
Applicable Ports
Yes
Coordinator Module
RS-422A
Yes
RS-232C port
Yes
Section 1-5