ZL50110GAG Zarlink, ZL50110GAG Datasheet - Page 65
![no-image](/images/manufacturer_photos/0/7/726/zarlink_sml.jpg)
ZL50110GAG
Manufacturer Part Number
ZL50110GAG
Description
CESoP Processor 552-Pin BGA Tray
Manufacturer
Zarlink
Datasheet
1.ZL50110GAG.pdf
(113 pages)
Specifications of ZL50110GAG
Package
552BGA
Maximum Data Rate
1000 Mbps
Transmission Media Type
Fiber Optic
Power Supply Type
Analog
Typical Supply Current
950(Max) mA
Typical Operating Supply Voltage
1.8 V
Minimum Operating Supply Voltage
1.65 V
Maximum Operating Supply Voltage
1.95 V
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
ZL50110GAG2
Manufacturer:
ZARLINK
Quantity:
60
ZL50110/11/12/14
Data Sheet
6.0
Clock Recovery
One of the main issues with circuit emulation is that the clock used to drive the TDM link is not necessarily linked
into the central office reference clock, and hence may be any value within the tolerance defined for that service.
The reverse link may also be independently timed, and operating at a slightly different frequency. In the
plesiochronous digital hierarchy the difference in clock frequencies between TDM links is compensated for using bit
stuffing techniques, allowing the clock to be accurately regenerated at the remote end of the carrier network.
With a packet network, that connection between the ingress and egress frequency is broken, since packets are
discontinuous in time. From Figure 6, the TDM service frequency f
at the customer premises must be exactly
service
reproduced at the egress of the packet network. The consequence of a long-term mismatch in frequency is that the
queue at the egress of the packet network will either fill up or empty, depending on whether the regenerated clock is
slower or faster than the original. This will cause loss of data and degradation of the service.
The ZL50110/11/12/14 provides clock recovery function to reproduce the TDM service frequency at the egress of
the packet network for structured and unstructured mode. Two schemes are employed, depending on the
availability of a common reference clock at each provider edge unit, differential and adaptive.
The adaptive and differential algorithms assume that there are no bit errors in the received packet header sequence
number or timestamp fields. If there are bit errors in the sequence number or timestamp fields, especially in the
most significant bits, then it is likely to cause a temporary degradation of the recovered clock performance. It is
advised to protect packets end-to-end (e.g., by using Ethernet FCS) such that packets with bit errors are discarded
and do not impact the recovered clock performance.
The clock recovery itself is performed by software in the host processor, with support from on-chip hardware to
gather the required statistics.
6.1
Differential Clock Recovery
For applications where the wander characteristics of the recovered clock are very important, such as when the
emulated circuit must be connected into the plesiochronous digital hierarchy (PDH), the ZL50110/11/12/14 also
offers a differential clock recovery technique. This relies on having a common reference clock available at each
provider edge point.
The differential algorithm assumes that the common clock is always present. There is no internal holdover
capability for the common clock source (e.g. TDM_CLKiP). If the availability of the common clock can not be
guaranteed, then it is recommended to use an external DPLL with holdover capability to provide a clock source at
all times. The external DPLL may enter holdover while the common clock is absent to maintain a relatively close
frequency to the original common clock.
In a differential technique, the timing of data packet formation is sent relative to the common reference clock. Since
the same reference is available at the packet egress point and the packet size is fixed, the original service clock
frequency can be recovered. This technique is unaffected by any low frequency components in the packet delay
variation. The disadvantage is the requirement for a common reference clock at each end of the packet network,
which could either be the central office TDM clock, or provided by a global position system (GPS) receiver.
65
Zarlink Semiconductor Inc.