ZFSM-201-KIT-1 CALIFORNIA EASTERN LABS, ZFSM-201-KIT-1 Datasheet - Page 15

• Manufacturer Part Number: ZFSM-201-KIT-1
• Manufacturer: CALIFORNIA EASTERN LABS

Specifications of ZFSM-201-KIT-1

• Lead Free Status / Rohs Status: Not Compliant

Sets the parameters of the ZFSM-201-EVB-1 FreeStar Pro evaluation board attached to the PC
by a USB cable.
All supported UART messages sent and received by the PC will be displayed.
The individual test tools available in the FreeStar Pro Test Tool software titled:
This area changes depending on the ‘Test Tool Tab’ selected. Please see individual
descriptions in Section 4.4.

















Transceiver ID: Enter the ID of the transmitter (1-65,535)
RF Channel:
RF Power:
18)
Set Settings:
memory of the module attached to the evaluation board
Get Settings:
Flash memory of the module attached to the evaluation board.
See “ZFSM-201-EVB-1 Module, Host and RF Protocol Guide” (CEL Doc #0006-00-08-
01-000) for a detailed list of supported messages and their frame formats.
Messages are listed with the most current on the top
Clicking the ‘Clear’ button will clear all messages in the log.
Checking the ‘Save to Log’ file will open a New save window. To save the log file, choose
the appropriate directory and click ‘Save’.
RF Evaluation (Section 4.4.1): Sets the mode of a single module for RF testing.
PERT (Section 4.4.2): Performs a Packet Error Rate Test on a pair of modules.
Range (Section 4.4.3): Sets up a single or periodic transmission between two modules.
Settings (Section 4.4.4): Queries the reference oscillator capacitor values and the ADC
values on the evaluation board.
Low Power (Section 4.4.5): Allows the user to put the evaluation board into various Sleep
modes for testing; enables the on-chip Buck Regulator (a hardware change is needed also)
See “ZFSM-201-KIT-1, ZFSM-201-EVB-1 Errata” (CEL Doc #0006-00-08-04-000) for further
information on the Buck Regulator.
Transceiver Info (Section 4.4.6): Reads firmware versions and transceiver statistics.
GPIO (Section 4.4.7): Reads or sets selected GPIO Outputs.
ED (Section 4.4.8): Performs an energy scan of the IEEE 802.15.4 2.4GHz channels.
4.2.2
4.2.3
4.2.4
4.2.5
Rev B
Transceiver Settings Window:
Communications Log Window:
Test Tool Tabs:
Test Tool Settings Window:
Enter the RF channel (11: 2405MHz ~ 26: 2480MHz).
Adjusts the Power Level of the Device from +5 to +20dBm (settings of 0 ~
Writes the ‘Transceiver ID’, ‘RF Channel’, and ‘RF Power’ to the Flash
Reads the ‘Transceiver ID’, ‘RF Channel’, and ‘RF Power’ from the
Document No. 0006-00-08-00-000
Page 15 of 42