ZFSM-201-KIT-1 CALIFORNIA EASTERN LABS, ZFSM-201-KIT-1 Datasheet - Page 33

• Manufacturer Part Number: ZFSM-201-KIT-1
• Manufacturer: CALIFORNIA EASTERN LABS

Specifications of ZFSM-201-KIT-1

• Lead Free Status / Rohs Status: Not Compliant

In the ‘PERT Setup’ Section:
1) Connect one of the evaluation boards to the PC through a USB cable and power up the board.
2) Follow connection procedures given in Section 4.3.1 until the Status is ‘Found FreeStar Pro Module’
3) Push ‘SWITCH 2’ on the evaluation board to configure the connected board as the Receiver.
4) In the ‘Transceiver Settings’ window, click the ‘Get Settings’ button to ensure the settings are:
5) Ensure that ‘Predefined’ is checked in the ‘Message Source’ section.
6) Check that the ‘Dest Address’ is ‘2020’.
7) Check that the ‘Source Address’ is ‘1010’.
8) Click the ‘Start PERT RX’ button to set up the Receiver. The Receiver Data should display the same
o
o
o
Rev B
‘Transceiver ID’:
‘RF Channel’:
‘RF Power’:
Note: The screenshot shows an SMAC configuration instead of a MAC configuration – See
Section 6.1 for more information with regards to RF Power).
Figure 26 – Screen, Test Tool – PERT Demo
‘2020’
’13 – (2415MHz)’
‘06’
Document No. 0006-00-08-00-000
Page 33 of 42