ATmega1284 Atmel Corporation, ATmega1284 Datasheet - Page 51

• Manufacturer Part Number: ATmega1284
• Manufacturer: Atmel Corporation

Specifications of ATmega1284

• Flash (kbytes): 128 Kbytes
• Pin Count: 44
• Max. Operating Frequency: 20 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 32
• Ext Interrupts: 32
• Usb Speed: No
• Usb Interface: No
• Spi: 3
• Twi (i2c): 1
• Uart: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Eeprom (bytes): 4096
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8 to 5.5
• Operating Voltage (vcc): 1.8 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 6
• Input Capture Channels: 1
• Pwm Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

11.1.2
8272C–AVR–06/11
Power-on Reset
Figure 11-1. Reset Logic
A Power-on Reset (POR) pulse is generated by an On-chip detection circuit. The detection level
is defined in
V
well as to detect a failure in supply voltage.
A Power-on Reset (POR) circuit ensures that the device is reset from Power-on. Reaching the
Power-on Reset threshold voltage invokes the delay counter, which determines how long the
device is kept in RESET after V
when V
CC
is below the detection level. The POR circuit can be used to trigger the start-up Reset, as
BODLEVEL [2..0]
CC
decreases below the detection level.
”System and Reset Characteristics” on page
ATmega164A/PA/324A/PA/644A/PA/1284/P
Pull-up Resistor
JTAG Reset
Register
FILTER
SPIKE
CC
CKSEL[3:0]
rise. The RESET signal is activated again, without any delay,
Power-on Reset
Reset Circuit
SUT[1:0]
Brown-out
Watchdog
Oscillator
Generator
Circuit
Clock
CK
Register (MCUSR)
MCU Status
DATA BUS
Delay Counters
337. The POR is activated whenever
TIMEOUT
51