ATmega64M1 Automotive Atmel Corporation, ATmega64M1 Automotive Datasheet - Page 353
ATmega64M1 Automotive
Manufacturer Part Number
ATmega64M1 Automotive
Description
Manufacturer
Atmel Corporation
Datasheets
1.AT90CAN128_AUTOMOTIVE.pdf
(225 pages)
2.ATMEGA16M1_AUTOMOTIVE.pdf
(25 pages)
3.ATMEGA16M1_AUTOMOTIVE.pdf
(367 pages)
Specifications of ATmega64M1 Automotive
Flash (kbytes)
64 Kbytes
Pin Count
32
Max. Operating Frequency
16 MHz
Cpu
8-bit AVR
# Of Touch Channels
12
Hardware Qtouch Acquisition
No
Max I/o Pins
27
Ext Interrupts
27
Usb Speed
No
Usb Interface
No
Spi
1
Uart
1
Can
1
Lin
1
Graphic Lcd
No
Video Decoder
No
Camera Interface
No
Adc Channels
11
Adc Resolution (bits)
10
Adc Speed (ksps)
125
Analog Comparators
4
Resistive Touch Screen
No
Dac Channels
1
Dac Resolution (bits)
10
Temp. Sensor
Yes
Crypto Engine
No
Sram (kbytes)
4
Eeprom (bytes)
2048
Self Program Memory
YES
Dram Memory
No
Nand Interface
No
Picopower
No
Temp. Range (deg C)
-40 to 150
I/o Supply Class
2.7 to 5.5
Operating Voltage (vcc)
2.7 to 5.5
Fpu
No
Mpu / Mmu
no / no
Timers
2
Output Compare Channels
14
Input Capture Channels
1
Pwm Channels
10
32khz Rtc
No
Calibrated Rc Oscillator
Yes
- AT90CAN128_AUTOMOTIVE PDF datasheet
- ATMEGA16M1_AUTOMOTIVE PDF datasheet #2
- ATMEGA16M1_AUTOMOTIVE PDF datasheet #3
- Current page: 353 of 367
- Download datasheet (7Mb)
7647G–AVR–09/11
Note:
Figure 30-1. The Break Field
5. Wrong TSOFFSET manufacturing calibration value.
6. PD0-PD3 set to outputs and PD4 pulled down following power-on with external
7. LIN Break Delimitter
Erroneous value of TSOFFSET programmed in signature byte.
(TSOFFSET was introduced from REVB silicon).
Problem fix / workaround
To identify RevB with wrong TSOFFSET value, check device signature byte at
address 0X3F if value is not 0X42 (Ascii code ‘B’) then use the following formula.
TS_OFFSET(True) = (150*(1-TS_GAIN))+TS_OFFSET.
reset active.
At power-on with the external reset signal active the four I/O lines PD0-PD3 may be
forced into an output state. Normally these lines should be in an input state. PD4 may
be pulled down with internal 220 kOhm resistor. Following release of the reset line
(whatever is the startup time) with the clock running the I/Os PD0-PD4 will adopt their
intended input state.
Problem fix / workaround
None
In SLAVE MODE, a BREAK field detection error can occur under following condi-
tions. The problem occurs if 2 conditions occur simultaneously:
a. The DOMINANT part of the BREAK is (N+0.5)*Tbit long with N=13, 14,15, ...
b. The RECESSIVE part of the BREAK (BREAK DELIMITER) is equal to 1*Tbit.
The BREAK_high is not detected, and the 2nd bit of the SYNC field is interpreted as the
BREAK DELIMITER. The error is detected as a framing error on the first bits of the PID
or on subsequent Data or a Checksum error.
There is no error if BREAK_high is greater than 1*Tbit + 18%.
There is no problem in Master mode.
Workaround
None
LIN2.1 Protocol Specification paragraph 2.3.1.1 Break field says: “A break field is always gener-
ated by the master task(in the master node) and it shall be at least 13 nominal bit times of
dominant value, followed by a break delimiter, as shown in
shall be at least one nominal bit time long.”
(see note below)
Break
field
Header
Sync
field
Inter-byte space
Protected
identifier
field
Atmel ATmega16/32/64/M1/C1
Frame
Break
Data 1
Response space
Data 2
Response
Inter-byte space
Figure
Data N
30-1. The break delimiter
Checksum
delimiter
Break
353
Related parts for ATmega64M1 Automotive
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Manufacturer:
Atmel Corporation
Datasheet:
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
High-performance EE PLD
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
8-bit Flash Microcontroller
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
2-Wire Serial EEPROM
Manufacturer:
ATMEL Corporation
Datasheet: