ATxmega128B1 Atmel Corporation, ATxmega128B1 Datasheet - Page 118

• Manufacturer Part Number: ATxmega128B1
• Manufacturer: Atmel Corporation

Specifications of ATxmega128B1

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 53
• Ext Interrupts: 53
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 3
• Twi (i2c): 1
• Uart: 2
• Segment Lcd: 160
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 4
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 8
• Eeprom (bytes): 2048
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 10
• Input Capture Channels: 10
• Pwm Channels: 10
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

38. Errata
38.1
38.1.1
8330B–AVR–10/11
ATxmega64B1, ATxmega128B1
Rev. C
•
1. JTAG Revision is unchanged between Rev. B and Rev. C
•
1. AWeX fault protection restore is not done correctly in Pattern Generation Mode
JTAG Revision
AWeX fault protection restore is not done correct in Pattern Generation Mode
When a fault is detected the OUTOVEN register is cleared, and when fault condition is
cleared, OUTOVEN is restored according to the corresponding enabled DTI channels. For
Common Waveform Channel Mode (CWCM), this has no effect as the OUTOVEN is correct
after restoring from fault. For Pattern Generation Mode (PGM), OUTOVEN should instead
have been restored according to the DTILSBUF register.
Problem fix/Workaround
For CWCM no workaround is required.
For PGM in latched mode, disable the DTI channels before returning from the fault condi-
tion. Then, set correct OUTOVEN value and enable the DTI channels, before the direction
(DIR) register is written to enable the correct outputs again.
For PGM in cycle-by-cycle mode there is no workaround
XMEGA B1
118