SAM3N2B Atmel Corporation, SAM3N2B Datasheet - Page 616

• Manufacturer Part Number: SAM3N2B
• Manufacturer: Atmel Corporation

Specifications of SAM3N2B

• Flash (kbytes): 128 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 48 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 23
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 47
• Ext Interrupts: 47
• Quadrature Decoder Channels: 2
• Usb Speed: No
• Usb Interface: No
• Spi: 3
• Twi (i2c): 2
• Uart: 4
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 10
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Dac Channels: 1
• Dac Resolution (bits): 10
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

• CPCDIS: Counter Clock Disable with RC Compare
0 = counter clock is not disabled when counter reaches RC.
1 = counter clock is disabled when counter reaches RC.
• EEVTEDG: External Event Edge Selection
• EEVT: External Event Selection
Signal selected as external event.
Note:
• ENETRG: External Event Trigger Enable
0 = the external event has no effect on the counter and its clock. In this case, the selected external event only controls the
TIOA output.
1 = the external event resets the counter and starts the counter clock.
• WAVSEL: Waveform Selection
• WAVE
0 = Waveform Mode is disabled (Capture Mode is enabled).
1 = Waveform Mode is enabled.
616
616
Value
Value
Value
0
1
2
3
0
1
2
3
0
1
2
3
1. If TIOB is chosen as the external event signal, it is configured as an input and no longer generates waveforms and subse-
SAM3N
SAM3N
quently no IRQs.
Name
NONE
RISING
FALLING
EDGE
Name
TIOB
XC0
XC1
XC2
Name
UP
UPDOWN
UP_RC
UPDOWN_RC
Description
None
Rising edge
Falling edge
Each edge
Description
TIOB
XC0
XC1
XC2
Description
UP mode without automatic trigger on RC Compare
UPDOWN mode without automatic trigger on RC Compare
UP mode with automatic trigger on RC Compare
UPDOWN mode with automatic trigger on RC Compare
(1)
TIOB Direction
input
output
output
output
11011A–ATARM–04-Oct-10
11011A–ATARM–04-Oct-10