SAM3N00A Atmel Corporation, SAM3N00A Datasheet - Page 484

• Manufacturer Part Number: SAM3N00A
• Manufacturer: Atmel Corporation

28.10.4.2
28.10.4.3
28.10.4.4
28.10.4.5
28.10.4.6
28.10.5
28.10.5.1
484
484
SAM3N
SAM3N
Data Transfer
Write Sequence
Clock Synchronization Sequence
General Call
PDC
DMAC
Read Operation
Note that a STOP or a repeated START always follows a NACK.
See
In the case of a Write sequence (SVREAD is low), the RXRDY (Receive Holding Register
Ready) flag is set as soon as a character has been received in the TWI_RHR (TWI Receive
Holding Register). RXRDY is reset when reading the TWI_RHR.
TWI continues receiving data until a STOP condition or a REPEATED_START + an address dif-
ferent from SADR is detected. Note that at the end of the write sequence TXCOMP flag is set
and SVACC reset.
See
In the case where TWI_THR or TWI_RHR is not written/read in time, TWI performs a clock
synchronization.
Clock stretching information is given by the SCLWS (Clock Wait state) bit.
See
In the case where a GENERAL CALL is performed, GACC (General Call ACCess) flag is set.
After GACC is set, it is up to the programmer to interpret the meaning of the GENERAL CALL
and to decode the new address programming sequence.
See
As it is impossible to know the exact number of data to receive/send, the use of PDC is NOT rec-
ommended in SLAVE mode.
As it is impossible to know the exact number of data to receive/send, the use of DMAC is NOT
recommended in SLAVE mode.
The read mode is defined as a data requirement from the master.
After a START or a REPEATED START condition is detected, the decoding of the address
starts. If the slave address (SADR) is decoded, SVACC is set and SVREAD indicates the direc-
tion of the transfer.
Until a STOP or REPEATED START condition is detected, TWI continues sending data loaded
in the TWI_THR register.
If a STOP condition or a REPEATED START + an address different from SADR is detected,
SVACC is reset.
Figure 28-25 on page 485
Figure 28-25 on page
Figure 28-26 on page
Figure 28-28 on page 487
Figure 28-27 on page
describes the write operation.
485.
485.
486.
and
Figure 28-29 on page
488.
11011A–ATARM–04-Oct-10
11011A–ATARM–04-Oct-10