LPC1776FBD208 NXP Semiconductors, LPC1776FBD208 Datasheet - Page 44

The LPC1776 is a Cortex-M3 microcontroller for embedded applications featuring a high level of integration and low power consumption at frequencies of 120 MHz

LPC1776FBD208

Manufacturer Part Number
LPC1776FBD208
Description
The LPC1776 is a Cortex-M3 microcontroller for embedded applications featuring a high level of integration and low power consumption at frequencies of 120 MHz
Manufacturer
NXP Semiconductors
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
LPC1776FBD208
Quantity:
10
Part Number:
LPC1776FBD208,551
Manufacturer:
NXP Semiconductors
Quantity:
10 000
NXP Semiconductors
LPC178X_7X
Objective data sheet
7.8.1 Features
7.8.2 Interrupt sources
7.10 External memory controller
7.8 Nested Vectored Interrupt Controller (NVIC)
7.9 Pin connect block
The NVIC is an integral part of the Cortex-M3. The tight coupling to the CPU allows for low
interrupt latency and efficient processing of late arriving interrupts.
Each peripheral device has one interrupt line connected to the NVIC but may have several
interrupt flags. Individual interrupt flags may also represent more than one interrupt
source.
Any pin on port 0 and port 2 regardless of the selected function can be programmed to
generate an interrupt on a rising edge, a falling edge, or both.
The pin connect block allows selected pins of the microcontroller to have more than one
function. Configuration registers control the multiplexers to allow connection between the
pin and the on-chip peripherals.
Peripherals should be connected to the appropriate pins prior to being activated and prior
to any related interrupt(s) being enabled. Activity of any enabled peripheral function that is
not mapped to a related pin should be considered undefined.
Most pins can also be configured as open-drain outputs or to have a pull-up, pull-down, or
no resistor enabled.
Remark: Supported memory size and type and EMC bus width vary for different parts
(see
Controls system exceptions and peripheral interrupts.
On the LPC178x/7x, the NVIC supports 40 vectored interrupts.
32 programmable interrupt priority levels, with hardware priority level masking.
Relocatable vector table.
Non-Maskable Interrupt (NMI).
Software interrupt generation.
Table
2). The EMC pin configuration for each part is shown in
All information provided in this document is subject to legal disclaimers.
Rev. 3 — 27 December 2011
32-bit ARM Cortex-M3 microcontroller
LPC178x/7x
Table
© NXP B.V. 2011. All rights reserved.
7.
44 of 120

Related parts for LPC1776FBD208