ST92124V1Q-Auto STMicroelectronics, ST92124V1Q-Auto Datasheet - Page 23

• Manufacturer Part Number: ST92124V1Q-Auto
• Description: 8-bit MCU for automotive
• Manufacturer: STMicroelectronics

Specifications of ST92124V1Q-Auto

• Internal Memory: Single Voltage FLASH up to 256 Kbytes, RAM up to 8Kbytes, 1K byte E3 TM (Emulated EEPROM)
• Minimum Instruction Time: 83 ns (24 MHz int. clock)

1.3 VOLTAGE REGULATOR
The internal Voltage Regulator (VR) is used to
power the microcontroller starting from the exter-
nal power supply. The VR comprises a Main volt-
age regulator and a Low-power regulator.
– The Main voltage regulator generates sufficient
– The separate Low-Power regulator consumes
Figure 16. Recommended Connections for V
IMPORTANT: The V
Figure 17. Minimum Required Connections for V
Note: Pin 31 of PQFP100 or pin 28 of LQFP100 can be left unconnnected. A secondary stabilization net-
work can also be connected to these pins.
C = 300 to 600nF
L = Ferrite bead for EMI protection.
Suggested type: Murata BLM18BE601FH1: (Imp. 600 Ω at 100 MHz).
C = 300 to 600nF
current for the microcontroller to operate in any
mode. It has a static power consumption (300
µA typ.).
less power is used only when the microcontrol-
ler is in Low Power mode. It has a different de-
sign from the main VR and generates a lower,
Pin 31
Pin 31
PQFP100
PQFP100
REG
pin cannot be used to drive external devices.
Pin 43
Pin 43
L
C
C
Pin 28
Pin 28
ST92124xxx-Auto/150xxxxx-Auto/250xxxx-Auto
LQFP100
REG
LQFP100
REG
For both the Main VR and the Low-Power VR, sta-
bilization is achieved by an external capacitor,
connected to one of the V
recommended value is 300 nF, and care must be
taken to minimize distance between the chip and
the capacitor. Care should also be taken to limit
the serial inductance to less than 60nH.
Pin 40
L
non-stabilized and non-thermally-compensated
voltage sufficient for maintaining the data in
RAM and the Register File.
Pin 40
C
C
Pin 28
Pin 28
QFP64
QFP64
REG
L
C
C
pins. The minimum
23/430
9