ATA8742 ATMEL Corporation, ATA8742 Datasheet - Page 204

• Manufacturer Part Number: ATA8742
• Manufacturer: ATMEL Corporation

30. Typical Characteristics – Preliminary Data
30.1
204
Active Supply Current
ATA8742
The data contained in this section is largely based on simulations and characterization of similar
devices in the same process and design methods. Thus, the data should be treated as indica-
tions of how the part will behave.
The following charts show typical behavior. These figures are not tested during manufacturing.
All current consumption measurements are performed with all I/O pins configured as inputs and
with internal pull-ups enabled. A sine wave generator with rail-to-rail output is used as clock
source.
The power consumption in Power-down mode is independent of clock selection.
The current consumption is a function of several factors such as: operating voltage, operating
frequency, loading of I/O pins, switching rate of I/O pins, code executed and ambient tempera-
ture. The dominating factors are operating voltage and frequency.
The current drawn from capacitive loaded pins may be estimated (for one pin) as C
C
The parts are characterized at frequencies higher than test limits. Parts are not guaranteed to
function properly at frequencies higher than the ordering code indicates.
The difference between current consumption in Power-down mode with Watchdog Timer
enabled and Power-down mode with Watchdog Timer disabled represents the differential cur-
rent drawn by the Watchdog Timer.
Figure 30-1. Active Supply Current vs. Low Frequency (0.1 - 1.0 MHz) - Temp.=25°C
Figure 30-2. Active Supply Current vs. Low Frequency (0.1 - 1.0 MHz) - Temp.=125°C
L
= load capacitance, V
1.2
0.8
0.6
0.4
0.2
1
0
0
0.1
CC
0.2
= operating voltage and f = average switching frequency of I/O pin.
ACTIVE S UP P LY CURRENT vs . LOW FREQUENCY
0.3
0.1 - 1.0 MHz - Temperature = 25˚C
0.4
Frequency (MHz)
0.5
0.6
0.7
0.8
0.9
9151A–INDCO–07/09
L
*
1
V
5.5 V
5.0 V
4.5 V
3.3 V
3.0 V
2.7 V
CC
*f where