TS80C51RA2 Atmel Corporation, TS80C51RA2 Datasheet - Page 25

• Manufacturer Part Number: TS80C51RA2
• Description: High Performance 8-bit Microcontroller
• Manufacturer: Atmel Corporation

Figure 8. PCA Interrupt System
4188A–8051–10/02
PCA Timer/Counter
Module 0
Module 1
Module 2
Module 3
Module 4
CMOD.0
ECF
The PCA interrupt system is shown in Figure 8.
PCA Modules: each one of the five compare/capture modules has six possible func-
tions. It can perform:
•
•
•
•
•
•
In addition, module 4 can be used as a Watchdog Timer.
Each module in the PCA has a special function register associated with it. These regis-
ters are: CCAPM0 for module 0, CCAPM1 for module 1, etc. (See Table 10). The
registers contain the bits that control the mode that each module will operate in.
•
•
•
•
•
16-bit Capture, positive-edge triggered,
16-bit Capture, negative-edge triggered,
16-bit Capture, both positive and negative-edge triggered,
16-bit Software Timer,
16-bit High Speed Output,
8-bit Pulse Width Modulator.
The ECCF bit (CCAPMn.0 where n=0, 1, 2, 3, or 4 depending on the module)
enables the CCF flag in the CCON SFR to generate an interrupt when a match or
compare occurs in the associated module.
PWM (CCAPMn.1) enables the pulse width modulation mode.
The TOG bit (CCAPMn.2) when set causes the CEX output associated with the
module to toggle when there is a match between the PCA counter and the module's
capture/compare register.
The match bit MAT (CCAPMn.3) when set will cause the CCFn bit in the CCON
register to be set when there is a match between the PCA counter and the module's
capture/compare register.
The next two bits CAPN (CCAPMn.4) and CAPP (CCAPMn.5) determine the edge
that a capture input will be active on. The CAPN bit enables the negative edge, and
the CAPP bit enables the positive edge. If both bits are set both edges will be
enabled and a capture will occur for either transition.
CF
ECCFn CCAPMn.0
CR
CCF4 CCF3 CCF2 CCF1 CCF0
IE.6
EC
IE.7
EA
priority decoder
CCON
0xD8
To Interrupt
TS8xC51Rx2
25