isl3873a Intersil Corporation, isl3873a Datasheet - Page 38

• Manufacturer Part Number: isl3873a
• Description: Wireless Lan Integrated Medium Access Controller With Baseband Processor
• Manufacturer: Intersil Corporation

Bit 2
Bit 1
Bit 0
Bits 7:0
Bit 7
Bits 6:0
Bit 7:5
Bits 4:0
Bit 7
Bit 6
Bit 5
Bits 4:0
Bits 7:4
Bits 3:0
Bits 7:4
Bits 4:0
Bits 7:6
Bits 5:0
CONFIGURATION REGISTER ADDRESS 36 (48h) R/W DELAY SPREAD THRESHOLD FOR CMF CONTROL
CONFIGURATION REGISTER ADDRESS 37 (4Ah) R/W CW RSSI THRESHOLD FOR CMF CONTROL
Internal digital loop back mode (SDI pin becomes LOCK input to acquisition block).
0 = normal chip operation loop back disabled.
1 = loop back enabled, A/D and D/A converters bypassed, chip will not respond to external signals.
enable PN to lower test bus address (2-0). For factory test.
0 = normal.
1 = PN to test bus address.
enable PN to upper test bus address (7-3). For factory test.
0 = normal.
1 = PN to test bus address.
Address bits for various tests. See Tech Brief #TB394 for a description of the test modes.
Energy Detect Threshold control.
0 = threshold is relative to noise floor.
1 = threshold is absolute.
ED Threshold. Range 0 - 127dBm. RSSI > threshold triggers ED.
Delay spread count. Range 0 - 7. Used for evaluation only.
Delay spread threshold. 0.xxxx.
This and the next 3 thresholds are used in the following formula to determine which CMF weights to use. CW detect is not
configurable.
If (CW and RSSI < (CW RSSI threshold + NoiseFloor)) or (no CW and RSSI < (SNR threshold #1 + NoiseFloor)) or (no CW
and delay spread < threshold and RSSI < (SNR threshold #2 + NoiseFloor)) then;
use Default CMF weights,
else,
use Calculated CMF weights.
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
Force default CMF weights.
0 = normal.
1 = force default CMF weights.
Force calculated CMF weights.
0 = normal.
1 = force calculated CMF weights.
Note: this cannot be combined with bit 6. A “1” on both will produce undefined results.
CW RSSI threshold, range 0 to 31dB.
CONFIGURATION REGISTER ADDRESS 38 (4Ch) R/W SNR THRESHOLD #1 FOR CMF CONTROL
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
SNR threshold #1 range 0 to 15dB.
CONFIGURATION REGISTER ADDRESS 39 (4Eh) R/W SNR THRESHOLD #2 FOR CMF CONTROL
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
SNR threshold #2, range 0 to 31dB.
R/W but not currently used internally, should be set to zero to ensure compatibility with future revisions.
DC offset Threshold, range 0 to 63dB. RSSI > (threshold + NoiseFloor) enables DC offset calculation and compensation.
CONFIGURATION REGISTER ADDRESS 33 (42h) R/W TEST MODES 2 (Continued)
CONFIGURATION REGISTER ADDRESS 40 (50h) R/W DC OFFSET THRESHOLD
38
CONFIGURATION REGISTER ADDRESS 34 (44h) R/W TEST BUS ADDRESS
CONFIGURATION REGISTER ADDRESS 35 (46h) R/W ED THRESHOLD
ISL3873A