tda7333 STMicroelectronics, tda7333 Datasheet - Page 17

• Manufacturer Part Number: tda7333
• Description: Rds/rbds Processor
• Manufacturer: STMicroelectronics

8.3 SPI mode
Figure 16. SPI data transfer
This interface consists of four lines. A serial data input (DATAIN), a serial data output (DATAOUT), a chip select
input (CSN) and a bit clock input (CLK).
The chip select input signals the begin and end of the data transfer. If the data transfer starts, at each
bit clock one bit is clocked out via the serial data output and one bit is clocked in via the serial data input.
When chip enable signals the begin of the data transfer the internal 64 bits shift register is updated with the cur-
rent registers content of the V324.
When chip enable signals the end of the data transfer the registers with write access can be updated with the
bits which have been last shifted in.
The last byte on DATAIN input is always rds_int[7:0] and the former last one is rds_bd_ctrl[7:0]. In other words,
the master has to take in account the amount of bytes transmitted when intending to perform a write operation
so that the last two bytes sent on DATAIN are rds_bd_ctrl[7:0] and rds_int[7:0].
If the update of both rds_int and rds_bd_ctrl registers is actually taking place depends on the MSB of rds_int,
i.e. rds_int[7] = 0 - no update, rds_int[7] = 1 update of both registers.
Hereafter you can find typical read/write access in spi mode :
Figure 17. write rds_int and rds_bd_ctrl registers in spi mode,reading RDS data and related flags
DATAOUT
DATAIN
DATAOUT
CSN
CLK
DATAIN
CSN
CLK
shiftregister with
registers content
update of
t
csu
rds_int[7:0]
rds_int[7]
shift of DATAIN
in shiftregister
1
t
rds_int[6]
su
2
rds_qu[7:0]
rds_int[5]
3
t
h
rds_int[4]
4
t
odv
rds_int[3]
rds_corrp[7:0]
t
5
oh
rds_int[2]
t
6
cl
t
ch
rds_int[1]
rds_bd_ctrl[7:0]
rds_bd_h[7:0]
7
rds_int[0]
8
{1,rds_int[6:0]}
rds_bd_l[7:0]
rds_int[1]
testreg[1]
63
testreg[0]
rds_int[0]
64
content if requested
update of registers
with shiftregister
t
csh
TDA7333
t
d
17/21