saa7130hl-v1 NXP Semiconductors, saa7130hl-v1 Datasheet - Page 23

• Manufacturer Part Number: saa7130hl-v1
• Description: Pci Video Broadcast Decoder
• Manufacturer: NXP Semiconductors

Philips Semiconductors
SAA7130HL_4
Product data sheet
6.6.5 Copy protection detection
6.6.6 Video scaling
The SAA7130HL detects if the decoded video signal is copy protected by the Macrovision
system. The detection logic distinguishes the three levels of the copy protection as
defined in rev. 7.01, and are reported as status information. The decoded video stream is
not effected directly, but application software and Operation System (OS) has to ensure
that this video stream maintains the ‘copy protected’ tag, and the video signal should
leave the system only with the reinforced copy protection. The multi-level Macrovision
detection on the video capture side supports proper TV re-encoding at the output point,
e.g. by Philips TV encoders SAA712x or SAA7102.
The SAA7130HL incorporates a filter and processing unit to downscale or upscale the
video picture in the horizontal and vertical dimension, and in frame rate
(see
original sample distance. This is equivalent to a clock jitter of less than 1 ns. The filter
depth of the anti-alias filter adapts to the scaling ratio, from 10 taps horizontally for scaling
ratios close to 1 : 1, to up to 74 taps for an icon sized video picture.
Most video capture applications will typically require downscaling. But some zooming is
required for conversion of ITU sampling to SQuare Pixel (SQP), or to convert the 240 lines
of an NTSC field to 288 lines to comply with ITU-T video phone formats.
The scaling acquisition definition also includes cropping, frame rate reduction, and defines
the amount of pixels and lines to be transported through DMA over the PCI-bus.
Two programming pages are available to enable re-programming of the scaler in the
‘shadow’ of the running processing, without holding or disturbing the flow of the video
stream. Alternatively, the two programming pages can be applied to support two video
destinations or applications with different scaler settings, e.g. firstly to capture video to
CPU for compression (storage, video phone), and secondly to preview the picture on the
monitor screen. A separate scaling region is dedicated to capture raw VBI samples, with a
specific sampling rate, and to write it into its own DMA channel.
Figure 9
and
Figure
Rev. 04 — 11 April 2006
10). The phase accuracy of the re-sampling process is
PCI video broadcast decoder
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
SAA7130HL
1
64
23 of 46
of the