sc16c652b NXP Semiconductors, sc16c652b Datasheet - Page 40

• Manufacturer Part Number: sc16c652b
• Description: 5v, 3.3 V And 2.5v Dual Uart, 5 Mbit/s Max. ,with 32-byte Fifos And Infrared Irda Encoder/decoder
• Manufacturer: NXP Semiconductors

Philips Semiconductors
13. Abbreviations
SC16C652B_4
Product data sheet
[4]
[5]
[6]
[7]
[8]
[9]
Table 31:
Acronym
FIFO
UART
CPU
ISDN
DMA
These packages are not suitable for wave soldering. On versions with the heatsink on the bottom side, the
solder cannot penetrate between the printed-circuit board and the heatsink. On versions with the heatsink
on the top side, the solder might be deposited on the heatsink surface.
If wave soldering is considered, then the package must be placed at a 45 angle to the solder wave
direction. The package footprint must incorporate solder thieves downstream and at the side corners.
Wave soldering is suitable for LQFP, QFP and TQFP packages with a pitch (e) larger than 0.8 mm; it is
definitely not suitable for packages with a pitch (e) equal to or smaller than 0.65 mm.
Wave soldering is suitable for SSOP, TSSOP, VSO and VSSOP packages with a pitch (e) equal to or larger
than 0.65 mm; it is definitely not suitable for packages with a pitch (e) equal to or smaller than 0.5 mm.
Image sensor packages in principle should not be soldered. They are mounted in sockets or delivered
pre-mounted on flex foil. However, the image sensor package can be mounted by the client on a flex foil by
using a hot bar soldering process. The appropriate soldering profile can be provided on request.
Hot bar soldering or manual soldering is suitable for PMFP packages.
Abbreviations
Description
First In, First Out
Universal Asynchronous Receiver/Transmitter
Central Processing Unit
Integrated Service Digital Network
Direct Memory Access
Rev. 04 — 1 September 2005
Dual UART with 32-byte FIFOs and IrDA encoder/decoder
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
SC16C652B
40 of 43