wm8350 Wolfson Microelectronics plc, wm8350 Datasheet - Page 137

no-image

wm8350

Manufacturer Part Number
wm8350
Description
Wolfson Audioplus? Stereo Codec With Power Management
Manufacturer
Wolfson Microelectronics plc
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
wm8350G
Manufacturer:
WOLFSON
Quantity:
20 000
Part Number:
wm8350GEB/RVLRG
Manufacturer:
WOLFSON
Quantity:
20 000
Production Data
14.7 CONFIGURING THE LDO REGULATORS
w
The configuration of the LDO Regulators is described in the following sections. Some of the control
fields form part of the Custom Mode configuration settings and therefore will not require to be set in
software in some applications.
14.7.1
The LDO Regulators can be enabled in software using the register fields defined in Table 81. To
reduce supply in-rush current, individual regulators should be programmed to start in different time
slots within the start-up sequence.
In the WM8350 ACTIVE state, the LDO Regulators can be enabled in software using the LDOn_ENA
bits. Setting these bits whilst in the Pre-Active state (see Figure 65) will not immediately enable the
corresponding LDO Regulators; these bits will only become effective once the WM8350 has reached
the ACTIVE state.
Each Regulator may be programmed to switch on in a selected timeslot within the start-up sequence.
The WM8350 will set the LDOn_ENA field for any LDO Regulator that is enabled during the start-up
sequence. Note that setting the LDOn_ENSLOT fields in software is only relevant to the
Development Mode, as these fields are assigned preset values in each of the Custom Modes.
Each Regulator may be programmed to switch off in a selected timeslot within the shutdown
sequence. If a Regulator is not allocated to one of the 14 shutdown timeslots, it will be disabled when
the WM8350 enters the OFF state.
R13 (0Dh) or
R176 (B0h)
DC-DC / LDO
requested
Note: These bits can be accessed through R13 or through R176. Reading from or writing to either
register location has the same effect.
ADDRESS
LDO REGULATOR ENABLE
BIT
10
11
8
9
LDO1_ENA
LDO2_ENA
LDO3_ENA
LDO4_ENA
LABEL
DEFAULT
0
0
0
0
LDO1 enable
0 = disabled
1 = enabled
Note: internal conditions may prevent the
converter from actually switching on -
see DCDC/LDO Status register for actual
converter status.
LDO2 enable
0 = disabled
1 = enabled
Note: internal conditions may prevent the
converter from actually switching on -
see DCDC/LDO Status register for actual
converter status.
LDO3 enable
0 = disabled
1 = enabled
Note: internal conditions may prevent the
converter from actually switching on -
see DCDC/LDO Status register for actual
converter status.
LDO4 enable
0 = disabled
1 = enabled
Note: internal conditions may prevent the
converter from actually switching on -
see DCDC/LDO Status register for actual
converter status.
DESCRIPTION
PD, June 2009, Rev 4.1
WM8350
137

Related parts for wm8350