bt8375kpf Conexant Systems, Inc., bt8375kpf Datasheet - Page 272

• Manufacturer Part Number: bt8375kpf
• Description: Single Chip Transceivers For T1/e1 And Integrated Service Digital Network Isdn Primary Rate Interfaces Systems
• Manufacturer: Conexant Systems, Inc.

4.0 Applications
4.1 External Component Specifications
Figure 4-3. Option C: Long Haul Application with No Ground Reference on the Line (2 of 2)
4-8
NOTE(S):
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Line side secondary surge protection to meet FCC Part 68, Bellcore TR-NWT-001089, and IEC 1000-4-5 requirements.
These components are: 1. TVS-LC01-6 Semtech, 2. PTC- TR600-160 Raychem, or 1. Thyristor (Sidactor)—Teccor
P0300SB, 2. PTC-TR600-160 Raychem can be used.
A LC01-6 device provides protection during high surge lightning tests. It is designed to shunt the surge current with a
maximum clamping voltage of 16 V maximum, below the transformer saturation point. A Thyristor (Sidactor—Teccor
P0300SB) clamps the voltage at 40 V maximum. A PTC device is used for power cross faults, meeting the requirements of
Bellcore 1089 and UL1459.
Chip side Secondary surge protection. Diodes should be low capacitance, fast turn-on Schottky or surge protection
diodes. These components are: 1. Schottky Diode—10BQ040 (surface mount) or 11DQ04 (discrete) International Rectifier
or one 20CJQ04 with two 10BQ040 2. two 2.1 , 1/4 W, 1% Resistors. The two 470
are used to limit the current going into the device and the power are off and T1/E1 lines are connected.
Optional programmable receive termination –75/100/120 .
Optional fixed transmit termination. The value shown provides acceptable transmit return loss for T1 and E1 applications.
Required fixed receive termination. The parallel combination of the fixed termination and programmable termination plus
the primary surge protection line feed resistor (PTC) must match the line impedance.
VSET Resistor. The VSET resistance value controls the transmit signal amplitude and depending on the line feed resistance
(PTC) in the primary surge protection circuit, its value can be fine-tuned. Use R (VSET) = 14 k if total line series resistance
is 0 to 12 .
The Physical area between the connector and chokes should be kept small in order to avoid high frequency coupling and to
improve emissions test. Another good option is to place chokes between PTC and the Line side surge protection device. If
common mode noise is a concern then use the through hole package (PE65854) at the connector.
Conexant
Fully Integrated T1/E1 Framer and Line Interface
resistors in series with RTIP/RRING
Bt8370/8375/8376
N8370DSE