kac-9630 ETC-unknow, kac-9630 Datasheet - Page 16

• Manufacturer Part Number: kac-9630
• Description: Cmos Image Sensor 126 H X 98 V Ultra Sensitive Global Shutter 580 Fps Monochrome Cis
• Manufacturer: ETC-unknow

IMAGE SENSOR SOLUTIONS
Register Set
Video Gain Programming Register
Register Name Video Gain Register
Address
Mnemonic
Type
Reset Value
Integration Time Programming Registers
Register Name Integration Time Low Register
Address
Mnemonic
Type
Reset Value
Idle Time Programming Register
Register Name Integration Time High Register
Address
Mnemonic
Type
Reset Value
Register Name Integration Time High Register
Address
Mnemonic
Type
Reset Value
www.kodak.com/go/imagers 585-722-4385
7
6
5
4:0
7:0
7:0
7:6
5:3
2:0
Bit
Bit
Bit
Bit
Offset-
DacEn
VidGain
Nint[7:0]
Nidle[7:0]
Nidle[10:8]
Nint[10:8]
Bit Symbol
Bit Symbol
Bit Symbol
Bit Symbol
02 Hex
VGAIN
Read/Write
00 Hex.
03 Hex
ITIMEL
Read/Write
0A Hex.
04 Hex
IDLE
Read/Write
00 Hex.
05 Hex
ITIMEH
Read/Write
00 Hex.
(continued)
Reserved
Assert to switch on the offset adjust-
ment bank.
Note that the OffsetBnkEn bit must
also be enabled.
(Default setting is logic 0)
Reserved
Use to program the overall video
gain.
Program to set the integration time of
the array.
Program to set the idle time of the
array. The minimum value that can
be programmed in this register is 01
hex.
Reserved
Program to set the idle time of the
array.
Program to set the integration time of
the array.
Description
Description
Description
Description
16
Register Name Power Setting Register
Address
Mnemonic
Type
Reset Value
Offset Adjustment Register
Register Name Offset Adjustment Register
Address
Mnemonic
Type
Reset Value
7:4
3:0
7
6
5:0
Bit
Bit
SetPower
OffSign
OffValue
Bit Symbol
Bit Symbol
06 Hex
POWSET
Read/Write
00 Hex.
08 Hex
OFFSET
Read/Write
00 Hex.
Program to increase or decrease the
sensor’s bias currents from the
default as follows
This should be programed once after
system reset.
Note that the OffsetBnkEn must be
set to enable this register.
Reserved
Sign of the offset adjust value. When
set to a logic 1, OffValue will be posi-
tive. When set to a logic 0 OffValue
will be negative.
note both OffsetBnk and Offset-
DacEn bits must be set to 1 before
this register can be used.
Reserved
Offset adjustment value. A positive
offset is added when OffSign is set to
a logic 1. A negative offset is added
when OffSign is set to a logic 0.
note both OffsetBnk and Offset-
DacEn bits must be set to 1 before
this register can be used.
SetPower
1111
0000
1110
Email:[e-mail]
Description
Description
Power
+6.7mA
0 mA
- 6.7mA