MC68HC08AZ60CFU MOTOROLA [Motorola, Inc], MC68HC08AZ60CFU Datasheet - Page 16

• Manufacturer Part Number: MC68HC08AZ60CFU
• Description: Advance Information
• Manufacturer: MOTOROLA [Motorola, Inc]

Power Supply Pins
(V
Oscillator Pins
(OSC1 and OSC2)
General Description
MC68HC08AZ60 — Rev 1.0
16
DD
and V
SS
NOTE:
)
V
from a single power supply.
Fast signal transitions on MCU pins place high, short-duration current
demands on the power supply. To prevent noise problems, take special
care to provide power supply bypassing at the MCU as shown in
3. Place the C1 bypass capacitor as close to the MCU as possible. Use
a high-frequency response ceramic capacitor for C1. C2 is an optional
bulk current bypass capacitor for use in applications that require the port
pins to source high current levels.
V
for the serial clock in the serial peripheral interface module (SPI). See
Serial Peripheral Interface Module (SPI)
V
The OSC1 and OSC2 pins are the connections for the on-chip oscillator
circuit. See
DD
SS
SS
Freescale Semiconductor, Inc.
is also the ground for the port output buffers and the ground return
must be grounded for proper MCU operation.
and V
For More Information On This Product,
SS
Clock Generator Module (CGM)
Go to: www.freescale.com
are the power supply and ground pins. The MCU operates
NOTE: Component values shown represent typical applications.
General Description
Figure 3. Power supply bypassing
V
DD
V
DD
MCU
0.1 F
+
C1
C2
on page 211.
V
on page 105.
SS
MOTOROLA
Figure
6-gen