DSPIC30F2010 MICROCHIP [Microchip Technology], DSPIC30F2010 Datasheet - Page 3

• Manufacturer Part Number: DSPIC30F2010
• Description: High-Performance, 16-Bit Digital Signal Controllers
• Manufacturer: MICROCHIP [Microchip Technology]

High-Performance Modified RISC CPU:
• Modified Harvard architecture
• C compiler optimized instruction set architecture
• 83 base instructions with flexible addressing
• 24-bit wide instructions, 16-bit wide data path
• 12 Kbytes on-chip Flash program space
• 512 bytes on-chip data RAM
• 1 Kbyte nonvolatile data EEPROM
• 16 x 16-bit working register array
• Up to 30 MIPs operation:
• 27 interrupt sources
• Three external interrupt sources
• 8 user-selectable priority levels for each interrupt
• 4 processor exceptions and software traps
DSP Engine Features:
• Modulo and Bit-Reversed modes
• Two 40-bit wide accumulators with optional
• 17-bit x 17-bit single-cycle hardware fractional/
• Single-cycle Multiply-Accumulate (MAC)
• 40-stage Barrel Shifter
• Dual data fetch
© 2006 Microchip Technology Inc.
Note: This data sheet summarizes features of this group
of dsPIC30F devices and is not intended to be a complete
reference source. For more information on the CPU,
peripherals, register descriptions and general device
functionality, refer to the “dsPIC30F Family Reference
Manual” (DS70046). For more information on the device
instruction set and programming, refer to the “dsPIC30F/
33F Programmer’s Reference Manual” (DS70157).
modes
- DC to 40 MHz external clock input
- 4 MHz-10 MHz oscillator input with
saturation logic
integer multiplier
operation
PLL active (4x, 8x, 16x)
28-Pin dsPIC30F2010 Enhanced Flash
16-Bit Digital Signal Controller
ds
Peripheral Features:
• High current sink/source I/O pins: 25 mA/25 mA
• Three 16-bit timers/counters; optionally pair up
• Four 16-bit capture input functions
• Two 16-bit compare/PWM output functions
• 3-wire SPI modules (supports 4 Frame modes)
• I
• Addressable UART modules with FIFO buffers
Motor Control PWM Module Features:
• 6 PWM output channels
• 4 duty cycle generators
• Dedicated time base with 4 modes
• Programmable output polarity
• Dead-time control for Complementary mode
• Manual output control
• Trigger for synchronized A/D conversions
Quadrature Encoder Interface Module
Features:
• Phase A, Phase B and Index Pulse input
• 16-bit up/down position counter
• Count direction status
• Position Measurement (x2 and x4) mode
• Programmable digital noise filters on inputs
• Alternate 16-bit Timer/Counter mode
• Interrupt on position counter rollover/underflow
Analog Features:
• 10-bit Analog-to-Digital Converter (ADC) with:
• Programmable Brown-out Reset
16-bit timers into 32-bit timer modules
- Dual Compare mode available
and 7-bit/10-bit addressing
- Complementary or Independent Output
- Edge and Center-Aligned modes
- 1 Msps (for 10-bit A/D) conversion rate
- Six input channels
- Conversion available during Sleep and Idle
2
PIC30F2010
C
modes
TM
module supports Multi-Master/Slave mode
DS70118G-page 1