MCF51JU128VHS FREESCALE [Freescale Semiconductor, Inc], MCF51JU128VHS Datasheet - Page 15

• Manufacturer Part Number: MCF51JU128VHS
• Description: MCF51JU128
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

1. The analog supply current is the sum of the active or disabled current for each of the analog modules on the device. See
2. 50 MHz core and system clocks, and 25 MHz bus clock. MCG configured for FEI mode. All peripheral clocks disabled.
3. 50 MHz core and system clocks, and 25 MHz bus clock. MCG configured for FEI mode. All peripheral clocks enabled, but
4. 50 MHz core and system clocks, and 25 MHz bus clock. MCG configured for FEI mode. All peripheral clocks enabled, and
5. 25 MHz core and system clocks, and 12.5 MHz bus clock. MCG configured for FEI mode.
6. 50 MHz core and system clocks, and 25 MHz bus clock. MCG configured for FEI mode.
7. 2 MHz core and system clocks, and 1 MHz bus clock. MCG configured for BLPE mode. All peripheral clocks disabled.
8. 2 MHz core and system clocks, and 1 MHz bus clock. MCG configured for BLPE mode. All peripheral clocks enabled, but
9. 2 MHz core and system clocks, and 1 MHz bus clock. MCG configured for BLPE mode. All peripheral clocks disabled.
10. OSC clocks disabled.
11. All pads disabled.
12. Data reflects devices with 32 KB of RAM. For devices with 16 KB of RAM, power consumption is reduced by 500 nA. For
5.2.5.1 Diagram: Typical IDD_RUN operating behavior
The following data was measured under these conditions:
DIAGRAM TBD
The following data was measured under these conditions:
Freescale Semiconductor, Inc.
Figure 1. Run mode supply current vs. core frequency — all peripheral clocks disabled
• MCG in FEI mode (39.0625 kHz IRC), except for 1 MHz core (FBE)
• All peripheral clocks disabled except FTFL
• LVD disabled, USB voltage regulator disabled
• No GPIOs toggled
• Code execution from flash memory
• MCG in FEI mode (39.0625 kHz IRC), except for 1 MHz core (FBE)
• All peripheral clocks enabled, but peripherals are not in active operation
each module's specification for its supply current.
peripherals are not in active operation.
peripherals are in active operation.
Code executing from flash memory.
peripherals are not in active operation. Code executing from flash memory.
devices with 8 KB of RAM, power consumption is reduced by 750 nA.
I
Symbol
DD_VLLS1
I
DD_OSC
Table 6. Power consumption operating behaviors (continued)
Very low-leakage stop mode 1 current at 3.0 V
Average current for OSC enabled with 32 kHz
crystal at 3.0 V
Description
• @ –40 to 25 °C
• @ 70 °C
• @ 105 °C
• @ –40 to 25 °C
• @ 70 °C
• @ 105 °C
MCF51JU128 Advance Information Data Sheet, Rev. 1, 08/2011.
Preliminary
Min.
—
—
—
—
—
—
TBD
TBD
TBD
TBD
Typ.
1.3
0.7
Nonswitching electrical specifications
Max.
TBD
TBD
TBD
—
—
—
Unit
μA
μA
μA
μA
μA
μA
Notes
10,11
15